Results 61 to 70 of about 1,195,933 (307)
This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm +6 more
wiley +1 more source
Electroreduction of CO2 on single atom catalysts is often hindered by electron delocalization of the metal sites. To improve CO2 activation, here the authors functionalize the carbon support with cyano moieties, thereby attenuating metal-substrate ...
Qiyou Wang +14 more
doaj +1 more source
Space-suit carbon dioxide absorption system: A concept [PDF]
Partial pressure of carbon dioxide within a space suit is maintained at safe levels by regenerating carbon dioxide with potassium hydroxide solution on board spacecraft or by portable ...
Copeland, R. J., Webbon, B. W.
core +1 more source
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
Electrophotolysis oxidation system for measurement of organic concentration in water [PDF]
Methods and apparatus for determining organic carbon in aqueous solution are described. The method comprises subjecting the aqueous solution to electrolysis, for generating oxygen from water, and simultaneously to ultraviolet radiation, for oxidation of ...
Winkler, H. E.
core +1 more source
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
The lower electricity consumption (EC) and higher value-added products are much desired yet still challenging for the development of CO2 coupling electrocatalytic systems.
Yi-Rong Wang +10 more
doaj +1 more source
New Directions in Transition Metal Catalyzed Carbonylation Chemistry
Carbon monoxide (CO) represents an important C1-building block for the construction of some of the most fundamental chemical functionalities carrying a carbon–oxygen double bond.
Dennis U. Nielsen +2 more
doaj +1 more source
Carbon dioxide as the working fluid in heating and/or cooling systems [PDF]
Despite vigorous research the use of carbon dioxide in the market is still relatively small. This is due to legislation, and technical difficulties of developing efficient, acceptable carbon dioxide ...
Fleming, J.S.
core
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source

