Results 61 to 70 of about 49,892 (307)
Investigation of the carbonization behavior of hybrid poplar
Carbonization experiments of hybrid poplar samples were performed in a thermogravimetric (TG) analyzer to investigate the effect of carbonization conditions, such as heating rate, particle size and sweep gas flow rate on the biochar yield.
Mericboyu, Ayseguel Ersoy +5 more
core +1 more source
Radiative Thermal Management for Extreme Environments: Mechanisms and Design Strategies
In this review, we discuss the fundamental mechanisms of radiative cooling and solar heating, material and structural design strategies, hybrid approaches integrating additional heat transfer pathways, and durability‐oriented designs addressing environmental stresses.
Hyung Rae Kim +5 more
wiley +1 more source
Preparation and Characterization of Sugar Based Catalyst on Various Supports
A novel structured carbon-based acid catalyst was prepared by depositing the carbon precursor onto glass, ceramic and aluminum supports via dip-coating method, followed by carbonization process for converting the d-glucose layer into black carbon char in
Jidon Adrian Janaun +3 more
doaj +1 more source
Ordered carbon/graphene composite nanofibers (CGCNFs) with different porous configurations were used as a material to fabricate supercapacitor electrodes.
Yi Wang +3 more
doaj +1 more source
Methanesulfonic Acid as a Dual‐Role Reagent for Porous Polymer Network Design
The design of porous polymer networks (PPNs) using methanesulfonic acid (MSA) as a dual‐role reagent facilitates the synthesis of robust PPNs for specific applications. It also makes the scale‐up process techno‐economically feasible because MSA functions simultaneously as both a solvent and a catalyst for the reaction.
Kelechi Festus +8 more
wiley +1 more source
Co-torrefaction of microalgae and lignocellulosic biomass was evaluated as a method to process microalgae sludge produced from various effluents and to obtain biochars with suitable properties for energy or material valorization.
Catarina Viegas +4 more
doaj +1 more source
Development of a novel method for synthesizing Ni single atom catalysts for highly selective electrochemical CO2 reduction in situ. This catalyst achieves 100% selectivity for CO and is formed in an industrially relevant cell architecture. Using post‐mortem XRD, STEM, and EDS and operando XAS, the identity of the active site and the mechanism behind ...
Ian Street +5 more
wiley +1 more source
The hardened cement paste powder (HCP) powder, devoid of the hydration cementing property, can be regenerated and cemented into a test block with practical strength of almost 60 MPa via CO2 carbonization using appropriate means.
Jie Yang +4 more
core +1 more source
Alternating oxidative–reductive pulses synchronize CO2‐derived *CO and NH3‐derived *NHx intermediates over dual Cu and Co single‐atom sites, enabling urea and ethyl urea formation with a total C─N Faradaic efficiency of 42 ± 4%. In situ spectroscopy and theoretical calculations elucidate complementary Cu and Co functions, while oxidative controls ...
Putri Ramadhany +8 more
wiley +1 more source
Carbon fiber from direct carbonization of PEDOT:PSS precursor fibers
An important factor limiting widespread carbon fiber utilization is the immense energy required for its manufacture. Specifically, the pre-carbonization stabilization processing step required for polyacrylonitrile and pitch fiber precursors accounts for ...
Leah E. Noble +5 more
doaj +1 more source

