Results 11 to 20 of about 137,536,807 (290)
Based on the characteristics and distribution patterns of collapsed holes in cast-in-place bored pile foundations in the typical coastal area of Guangdong Petrochemical Company, the deformation and collapse behavior of pile walls in the project zone were
Lu Guo +3 more
doaj +2 more sources
Compared with conventional piles such as the circle pile, the cast-in-place large-diameter pile (PCC pile) has many advantages: the lateral area of PCC pile is larger and the bearing capacity of PCC pile is higher.
Lei Gao +3 more
doaj +2 more sources
Interface Detection of Concrete and Slurry in Cast-in Place Pile
To find the interface of concrete and slurry in a cast-in place pile, the numerical simulation method and Laboratory tests are performed. Pressures along a pipe were obtained. Differential pressures of fixed distance were calculated.
Liu Zhaolei, Yu Lei, Zhang Shuxiong
doaj +3 more sources
A Method for Detecting Cast-in-Place Bored Pile Top Surface Based on Full Waveform Inversion
Real-time monitoring of the pile foundation pouring status is the key to ensuring the quality and reliability of cast-in-place bored pile foundation structures.
Ming Chen +6 more
doaj +2 more sources
The Cast-in-place concrete large-diameter pipe (PCC) pile has been used as the foundation reinforcement and embankment in China due to its low cost and high bearing capacity.
Lei Gao +5 more
doaj +2 more sources
An Application of BOTDR to the Measurement of the Curing of a Bored Pile
In order to study the deformation of a bored pile during concrete curing, it is necessary to monitor the strain of the pile. In this paper, Brillouin optical time domain reflectometer (BOTDR) technology is used to monitor the pile strain during concrete ...
Lei Gao +4 more
doaj +2 more sources
Dynamic testing of cast-in-place piles
This report presents the results of dynamic testing of two 21-in. (20-in. nominal) diameter Franki piles 44 and 55.5 ft long measured to the top of the bulb. The longer pile had a built-in fault, which was a reduction of the cross-sectional area by 50 per cent over a 2-ft length, the middle of which was located approximately 15 ft above the bulb.
Ferahian, R. H.
openaire +4 more sources
As a key form of deep foundation in civil engineering, the concrete pouring quality of cast-in-place piles directly determines the integrity and long-term bearing performance of the pile body.
Ming Chen +3 more
doaj +2 more sources
To study the effect of length-diameter ratio and mudcake on the bearing capacity of bored cast-in-place piles, the indoor model test and finite element numerical simulation method were used to carry out the loading test of piles under different mudcake ...
Peisheng Xi, Mengxuan Kan, Yang Liu
doaj +1 more source
Experimental study on bearing mechanism of screw cast-in-place piles under vertical loads
The screw cast-in-place pile is a kind of variable-section cast-in-place pile with cylindrical top and threaded bottom. Due to its special construction technology and section form, the bearing mechanism of screw piles is different from that of piles with
WANG Shu-guang 1, 2, FENG Zhe 3, TANG Jian-zhong 1, ZHAO Zhi-peng 1
doaj +1 more source

