Results 71 to 80 of about 12,264 (293)

Engineered AuNPs/fMWCNT Nanocomposite Electrodes for High‐Sensitivity Methylglyoxal Sensing in Saliva and Sweat for Non‐Invasive Diabetes Monitoring

Advanced Healthcare Materials, EarlyView.
An AuNPs/fMWCNT nanocomposite‐modified screen‐printed carbon electrode was engineered via sequential electrodeposition and integrated into a 3D‐printed microfluidic platform for ultrasensitive methylglyoxal detection. The non‐invasive sensing platform enables rapid analysis in saliva and sweat, highlighting strong potential for wearable point‐of‐care ...
Ahadul Amin Soshi, Md Younus Ali, Dadbeh Pazuki, Matiar M.R. Howlader   +3 more
wiley   +1 more source

Cathodic Protection

Transactions of The Electrochemical Society, 1942
If the corrosion is electrochemical, it may be concluded from this work that: 1. In order that protection may be complete, the potential of the cathode areas must be polarized to a potential equal to or more anodic than the open circuit potential of the anodes. 2.
R. H. Brown, R. B. Mears
openaire   +1 more source

ECorr: Cathodic Protection

, 2010
This case study presents an investigation into the corrosion protection of a steel oil platform submerged in sea water. Cathodic protection is highlighted as the most economic and the implementation of a cathodic protection system is explored in detail.
Salah Faidi, University of Manchester, Prof Anne Neville, University of Leeds, Dr Trevor Hodgkiess, University of Glasgow, Dr Peter Boden, University of Nottingham, Prof Bob Cottis, Corrosion and Protection Centre, University of Manchester   +4 more
core  

POM‐Based Water Splitting Catalyst Under Acid Conditions Driven by Its Assembly on Carbon Nanotubes

Advanced Materials, EarlyView.
A newly‐engineered POM‐based electrocatalyst incorporating non‐innocent counter cations exhibits fast kinetics for either the OER or HER under strongly acidic conditions (1 m H2SO4), depending on whether it is assembled on carbon nanotubes (1@CNT) or physically mixed with them (1/CNT). In water‐splitting tests using a two‐electrode setup, these systems
Eugenia P. Quirós‐Díez, Melanie Guillén‐Soler, Carlos Herreros‐Lucas, Alejandro López‐Moreno, José Manuel Vila‐Fungueiriño, Antonio Luis Llamas‐Saiz, Karol Strutyński, Manuel Melle‐Franco, María del Carmen Giménez‐López   +8 more
wiley   +1 more source

SACRIFICIAL ANODE CATHODIC PROTECTION OF LOW CARBON STEEL IN SEA WATER

Journal of Engineering, 2007
Cathodic protection is a corrosion-prevention technique which uses the electrochemical properties of metals to insure that the structure to be protected becomes the cathode of an electrolytic cell.
Aprael S. Yaro, Khalid W. Hameed
doaj   +1 more source

Transparent Perovskite Light‐Emitting Diodes with Conductive Oxide Top Electrodes

Advanced Materials, EarlyView.
Transparent perovskite light‐emitting diodes (TrPeLEDs) enable simultaneous display and transparency, expanding application possibilities. Using a metal oxide buffer layer and pulsed laser deposition, TrPeLEDs with diverse compositions and architectures are demonstrated.
Michele Forzatti, Sergio Martínez‐Saiz, Morena Cervino, Edoardo Stanzani, Sandra Jenatsch, Qingsen Zeng, Joo Sung Kim, Dong‐Hyeok Kim, Eojin Yoon, Tae‐Woo Lee, Daniel Tordera, Henk J. Bolink   +11 more
wiley   +1 more source

Case Analysis of the Diagnosis and Mitigation of Internal and External Interference at a Typical Natural Gas Transmission Station with Combined Cathodic Protection [PDF]

Cailiao Baohu
A study was conducted to address the unresolved problem of excessively negative pipe/ soil potentials on the external pipeline after combined internal and external cathodic protection had been implemented at a certain natural gas transmission station ...
ZHAO Yunli
doaj   +1 more source

Laser‐Assisted Phase Engineering of 2D MoS2 for Efficient Solution‐Processed Electronics

Advanced Materials, EarlyView.
Here, local laser‐assisted phase transition from solution‐processed phase‐pure 1T′ to 2H MoS2 is shown to critically depend on the irradiation atmosphere. While processing in air leads to damaged insulating regions, inert conditions yield semiconducting 2H domains, enabling direct field‐effect transistor patterning with optimized lateral 1T′‐2H MoS2 ...
Anna Zhuravlova, Minjuan Li, Osamah Alharbi, Yeonsu Jeong, Bin Han, Lei Gao, Mischa Bonn, Mario Lanza, Sheng Yang, Antonio Gaetano Ricciardulli, Paolo Samorì   +10 more
wiley   +1 more source

SACRIFICIAL ANODE CATHODIC PROTECTION OF LOW CARBON STEEL IN SEA WATER

Journal of Engineering, 2006
Cathodic protection is a corrosion-prevention technique which uses the electrochemical properties of metals to insure that the structure to be protected becomes the cathode of an electrolytic cell Laboratory evaluation was conducted on zinc electrode ...
Aprael S. Yaro, Khalid W. Hameed
doaj   +1 more source

Phase Engineering of Nanomaterials (PEN): Evolution, Current Challenges, and Future Opportunities

Advanced Materials, EarlyView.
This review summarizes the synthesis, phase transition, advanced characterization spanning ex situ to in situ and operando techniques, and diverse applications of phase engineering of nanomaterials (PEN). It further outlines key challenges and future opportunities, such as phase stability, architecture control, and artificial intelligence (AI)‐driven ...
Ye Chen, Zhanxi Fan, Jingjie Ge, Qiyuan He, Zhuangchai Lai, Jiawei Liu, Chaoliang Tan, Hua Zhang   +7 more
wiley   +1 more source