Results 51 to 60 of about 97,295 (251)
Advances in Civil Engineering, 2021 In the current work, the thermal energy storage cement mortars were prepared by physical mixing between cement mortar and form-stable hydrated salt based on disodium hydrogen phosphate dodecahydrate/carbon nanofiber-expanded graphite (DSP/CNF-EG).
Kunyang Yu +3 more
doaj +1 more source
Efeito da pré-molhagem do agregado nas propriedades das argamassas com agregado reciclado deconcreto e agregado leve [PDF]
, 2019 This paper examines the suitability of partially replacing natural aggregate, sand, (NA) with recycled concrete aggregate (RCA) or lightweight aggregate (LWA) in mortars, under the hypothesis that pre-wetting aggregates would produce improvement in ...
Aponte Hernández, Diego Fernando +3 more
core +4 more sources
Journal of Applied Polymer Science, EarlyView.Surface functionalization of polypropylene macrofibers to enhance fiber‐matrix interfacial bonding. ABSTRACT Concrete is the most used higher compressive strength‐building material, albeit brittle to tensile, and flexural loads. Polypropylene (PP) synthetic polymeric macrofibres are commonly employed as reinforcement material to prevent this situation ...
Elena Saccani +3 more
wiley +1 more source
Failure and impact behavior of facade panels made of glass fiber reinforced cement(GRC) [PDF]
, 2011 GRC is a cementitious composite material made up of a cement mortar matrix and chopped glass fibers. Due to its outstanding mechanical properties, GRC has been widely used to produce cladding panels and some civil engineering elements.
A. Enfedaque +18 more
core +3 more sources
The properties of recycled rubber from waste tires in the production of cement composites [PDF]
, 2020 This article presents the results of a study dealing with the use of a combination of recycled rubber from waste tires as a 100% substitute in the production of cement composites.
Charvát, Jakub +5 more
core +1 more source
Deep Underground Science and Engineering, EarlyView.This article aims to investigate the dynamic fracture response of fractured tunnel models under zero geological stress through physical experiments and numerical simulations. It further simulates the dynamic fracture characteristics of fractured tunnel models under geological stress ranging from 0 to 2.5 MPa using the numerical software AUTODYN ...
Peng Ying +7 more
wiley +1 more source
Microstructure tests, flow, and mechanical behavior of polymerized cement mortar
Ain Shams Engineering Journal, 2023 The influence of two types of polymeric admixture on the stress–strain (σ-ε) behavior of cement mortar is discussed in this article. The characteristics of cement mortars modified with two types of polymeric admixtures containing 0.20 percent (% wt ...
Ahmed Salih Mohammed +4 more
doaj +1 more source
Effect on compressive strength of epoxy-modified mortar with further dry-curing [PDF]
, 2015 The percentage of concrete porosity will affects the strength and performance of the concrete. It is believed that, with an additional curing, the porosity of the concrete becomes lower and the strength will increase.
Ariffin, Nur Farhayu +4 more
core
Setting control of completely recyclable concrete with slag and aluminate cements [PDF]
, 2016 A completely recyclable concrete (CRC) is designed to have a chemical composition equivalent to the one of general raw materials for cement production. By doing so, this CRC can be used at the end of its service life in cement manufacturing without the ...
De Belie, Nele +3 more
core +2 more sources
Review and prospects of shear test of bolted rock joints
Deep Underground Science and Engineering, EarlyView.The laboratory shear test equipment, test method, and numerical simulation of bolted rock joints were summarized. The shortcomings and limitations of the current research were analyzed, and the research prospects were proposed. Abstract Rock bolting is a critical approach in geotechnical engineering for supporting weak rocks.
Shulin Ren +4 more
wiley +1 more source