Results 91 to 100 of about 33,572 (231)

Design of Foaming Fluid-cement Slurry Mixer Based on Jet Pump Principle

open access: yesShiyou jixie, 2018
The foaming fluid-cement slurry mixer is an important equipment for producing foamed cement by chemical gas generation. Based on the basic principle of jet pump, the basic performance equation, cavitation performance equation and optimal parameter ...
Wang Qingqun
doaj  

Bentonite hydration effects on the engineering properties of a cement - sodium silicate slurry

open access: yesCase Studies in Construction Materials
Because of the advantages of good fluidity, short gelation time and high compressive strength, cement - sodium silicate slurry is widely used in shield engineering.
Shengwei Wang, Yangjian Li, Bangbang Lu
doaj   +1 more source

Experimental Study on Performance of Modified Cement-Clay Grouting Materials in Dynamic Water Environments

open access: yesRenmin Zhujiang
Grouting technology is a crucial method for mitigating karst water inrush disasters. However, traditional grouting materials have obvious limitations in dealing with high-pressure and high flow dynamic water environments, such as poor anti-dispersion ...
WANG Zhuqiao, JIANG Huangbin
doaj  

Use of reinforced inorganic cement materials for spark wire and drift chamber wire frames [PDF]

open access: yes
The results of a survey, materials test, and analysis study directed toward the development of an inorganic glass-fiber reinforced cement material for use in the construction of space qualified spark wire frames and drift chamber frames are presented ...

core   +1 more source

Ultrasonic sound speed of hydrating calcium sulphate\ud hemihydrate; part 2, the correlation of sound velocity to\ud hydration degree [PDF]

open access: yes, 2011
In this article the sound velocity through a mix is correlated to the hydration degree of\ud the mix. Models are presented predicting the sound velocity through fresh slurries and\ud hardened products.
Brouwers, H.J.H., Korte, A.C.J. de
core   +2 more sources

Impact of super absorbent polymers on early age behavior of ultra-high performance concrete walls [PDF]

open access: yes, 2019
Early age cracking, a common problem for Ultra-High Performance Concrete (UHPC), is caused by Autogenous Shrinkage (AS) and self-desiccation arising from the chemical shrinkage during the cement hydration reactions when the deformation is restrained ...
De Belie, Nele   +7 more
core  

Motion of Air Bubbles in a Cement Slurry. [PDF]

open access: yesMaterials (Basel), 2023
Konan NA, Rosenbaum E, Massoudi M.
europepmc   +1 more source

Attachment system for silica tiles [PDF]

open access: yes, 1982
An improved method for markedly increasing the bond strength between a rigid, porous refractory material and non-rigid substrate by densifying the face of the rigid material opposing the substrate is discussed.
Dotts, R. L., Holt, J. W.
core   +1 more source

Experimental study on grout diffusion patterns and reinforcement effect of sand stratum based on laboratory tests

open access: yesAIP Advances
To investigate the diffusion and reinforcement effects of different slurries in the sand stratum, the grouting reinforcement simulation laboratory test system was developed.
Haotian Guo   +4 more
doaj   +1 more source

Use of superabsorbent polymers to mitigate autogenous shrinkage in ultra-high performance concrete [PDF]

open access: yes, 2019
Ultra-high performance concrete (UHPC) with low w/c-ratio is very prone to the formation of cracks due to autogenous shrinkage. These cracks can lead to a decreased durability of the concrete, resulting in higher maintenance and/or repair costs in the ...
De Belie, Nele   +5 more
core  

Home - About - Disclaimer - Privacy