Results 11 to 20 of about 3,692 (235)

Ancient Wall Tiles – The Importance of the Glaze/Ceramic Interface in Glaze Detachment

open access: yesMedžiagotyra, 2014
One of the most severe pathologies suffered by early industrially produced tiles in Portugal in late nineteenth century is glaze detachment in wall tiles placed in the lower part of the façade.
Marisa COSTA   +4 more
doaj   +2 more sources

Breaking Preconceptions: Thin Section Petrography For Ceramic Glaze Microstructures [PDF]

open access: yes, 2021
During the last thirty years, microstructural and technological studies on ceramic glazes have been essentially carried out through the use of Scanning Electron Microscopy (SEM) combined with energy dispersive X-ray analysis (EDX).
Melgarejo i Draper, Joan-Carles   +4 more
core   +3 more sources

Glass–ceramic glazes for ceramic tiles: a review [PDF]

open access: yesJournal of Materials Science, 2011
Glass–ceramics are ceramic materials produced through controlled crystallisation (nucleation and crystal growth) of a parent glass. The great variety of compositions and the possibility of developing special microstructures with specific technological properties have allowed glass–ceramic materials to be used in a wide range of applications.
R. Casasola, J. Ma Rincón, M. Romero
openaire   +1 more source

Improvement of mechanical properties, microscopic structures, and antibacterial activity by Ag/ZnO nanocomposite powder for glaze-decorated ceramic

open access: yesJournal of Advanced Ceramics, 2017
With the increase in the international trade of ceramics, improvement in the physical and chemical properties of ceramics has become a market demand in recent years.
Qian Zhang, Lv Si Xu, Xiaoyan Guo
doaj   +1 more source

Surface modification study of CaO-Al2O3-SiO2-Fe2O3 base system high temperature phase reconstruction

open access: yesFrontiers in Materials, 2023
The fly ash was used as raw material to prepare glass ceramic base body, on which a layer of glaze slurry was applied, then, the complex was successfully prepared by sintering at 1180 °C through single-sinter process. Influences of quartz sand content on
Huanyin Yang   +7 more
doaj   +1 more source

Investigation of the Usage Properties of Steel Slag as Pigment in Low-Temperature Glaze

open access: yesSakarya Üniversitesi Fen Bilimleri Enstitüsü Dergisi, 2023
The evaluation of industrial wastes in the ceramics industry has been the subject of research studies in recent years. This study investigated the use of steel slag as a colouring pigment in ceramic glazes.
Muhterem Koç, Eda Taşçı
doaj   +1 more source

Improving adhesion between luting cement and zirconia-based ceramic with an alternative surface treatment

open access: yesBrazilian Oral Research, 2015
This study evaluated the influence of an alternative surface treatment on the microshear bond strength (μsbs) of zirconia-based ceramic. Thirty-five zirconia disks were assigned to five groups according to the following treatments: Control (CO), glass ...
Aurealice Rosa Maria MARTINS   +4 more
doaj   +1 more source

Concentrations of natural radionuclides in imported zirconium minerals [PDF]

open access: yesNuclear Technology and Radiation Protection, 2011
The natural radioactivity in imported zircon samples used as glaze for ceramic tiles in the ceramics industry has been presented in this paper. The measurements were made by gamma spectrometry with a high purity germanium detector.
Janković Marija M.   +1 more
doaj   +1 more source

Technical factors affecting the luster and shine development in Islamic metallic luster between (9-15) AD

open access: yesJournal of Architecture, Art & Humanistic Science, 2021
Islamic metallic luster is one of the historical Islamic ceramic techniques that appeared in some Islamic states in periods of the century (9-15) AD, it appeared at first in Iraq, then in Egypt, then in Syria and Iran, then in Andalusia (currently Spain),
Nawal Ahmed Ibrahem Khedre
doaj   +1 more source

Study of highly reflective ceramic glaze coating and laser irradiation effects

open access: yesMaterials & Design, 2023
The rapid development and wide application of laser technology, together with the gradually increased output energy of lasers, pose a great threat to safety. Therefore, the demand for anti-laser is urgent.
Mingzhe Li   +3 more
doaj   +1 more source

Home - About - Disclaimer - Privacy