Results 91 to 100 of about 22,221 (266)
The fused data extracted from the distributed monitoring system as the data basis, combined with dynamic geological data, are imported into a deep learning model. As the geological conditions of mining and excavation change, the risk of water inrush at the working face is retrieved in real time.
Yongjie Li +4 more
wiley +1 more source
A CFD simulation of the condensation flow of R600a and R290 within microchannels was conducted to explore the effect of mass flux, hydraulic diameter, and vapour quality on heat transfer rate and pressure drop.
Anıl Başaran, Ali Cemal Benim
doaj +1 more source
To address seepage‐induced tunnel face collapse, this study develops a two‐phase double‐point MPM framework to capture large‐deformation hydro‐mechanical interactions. Incorporating a cementation‐based constitutive model with dynamic permeability updates, the model is successfully validated against saturated granular‐column collapse experiments ...
Yue Tong +6 more
wiley +1 more source
Wind tunnel tests or computational fluid dynamics (CFD) simulations of the aeroelastic model of a bridge deck section are currently used to make sure that significant vortex-induced vibration (VIV) of a long-span bridge will not occur after the bridge is
Hao-Yang Li +5 more
doaj +1 more source
Low‐dimensional materials (0D, 1D, and 2D) exhibit unique electronic and physicochemical properties, enabling advanced nanoelectronic and optoelectronic devices. Mixed‐dimensional heterostructures combine these materials to enhance functionality.
Qaisar Alam +3 more
wiley +1 more source
Three‐turbine guided Savonius arrays installed along highway corridors extract up to 697 J under multi‐vehicle wake conditions when spaced 12 rotor diameters apart—68% more than compact arrangements. Guide vanes boost output by 80–120%, and interior turbines respond most strongly to spacing, governing overall array performance. ABSTRACT Highway‐induced
Aydin Ulus, Stefan Ilie Moldovan
wiley +1 more source
Abstract 3D scanning is rapidly becoming a key maintenance tool. Aerospace was a pioneer in adopting 3D scanning technology because aircraft manufacture and maintenance require precision. Monitoring deterioration, removing components for maintenance, and verifying covert operations are not practical or helpful without technology.
T. Nanthakumaran Thulasy +4 more
wiley +1 more source
A Control Strategy With Hybrid Compressor Modeling for Electric Vehicle CO2 Heat Pump Systems
A hybrid PSO‐BP compressor sub‐model is developed and embedded in a MATLAB/Simscape physical model of a transcritical CO2 heat pump system for electric vehicles. Based on this high‐fidelity platform, a phased variable‐PTC cooperative control strategy is proposed and evaluated.
Jiaqi Dong +5 more
wiley +1 more source
This critical review integrates wall‐condensation configurations, governing transport mechanisms, modelling approaches, and validation evidence into a unified framework for assessing predictive applicability. The framework supports evidence‐based model selection and preliminary condenser design by considering heat‐transfer area, pressure‐drop ...
Md. Jisan Mahmud +2 more
wiley +1 more source
Non-Newtonian and Gas-non–Newtonian Liquid Flow through Elbows – CFD Analysis
Computational Fluid Dynamics (CFD) analysis for the flow of non-Newtonian and gas-non-Newtonian liquid through elbows is presented. The commercial software Fluent 6.3 has been used for the simulation.
T.K Bandyopadhyay, S. K Das
doaj

