Results 121 to 130 of about 57,914 (179)
Structural Concrete, EarlyView.Abstract In practice, reinforced concrete (RC) wall‐like columns often have openings to facilitate building services, which creates stress concentrations around the opening, resulting in the weakening of their load‐carrying capacity. This study proposes innovative strengthening methods using near‐surface mounted (NSM) incorporating steel materials to ...
Ahmed Hamoda +4 more
wiley +1 more source
Research on a Drone‐Based Vacant Parking Detection System
IEEJ Transactions on Electrical and Electronic Engineering, EarlyView.It can be difficult to know which spaces are available in parking lots and bicycle parking areas, so knowing the availability status is necessary for efficient parking. Therefore, in this study, we developed the drone that can display the availability status. Availability is determined by whether it can read a QR code attached to the ground. To conduct
Hiroki Mineshita +2 more
wiley +1 more source
Fatigue &Fracture of Engineering Materials &Structures, EarlyView.ABSTRACT In this study, the influence of resin cross‐link density on thermomechanical properties and fatigue behavior of polyurethane resins and glass fiber‐reinforced polyurethane (PUR‐GFRP) composites was investigated. This material is a candidate for renewable energy applications like rotor blades in wind turbines.
Martin Demleitner +5 more
wiley +1 more source
Design philosophy issues of fiber reinforced polymer reinforced concrete structures
, 2002 The conventional design philosophy for reinforced concrete (RC) relies heavily on the ductile properties of steel. These ductile properties are used as a "fuse" and conceal the large uncertainty in the determination of modes of failure caused ...
Guadagnini, M. +2 more
core
Mechanical and Microstructural Characterization of Hybrid Palm Fiber–Carbon Fiber Composites
SPE Polymers, Volume 7, Issue 2, April 2026.ABSTRACT Hybrid fiber‐reinforced polymer composites combining natural and synthetic reinforcements offer a promising route toward lightweight and sustainable structural materials. In this study, carbon fiber–palm tree fiber reinforced epoxy hybrid composites were fabricated using a hand lay‐up technique with a symmetric sandwich‐type stacking sequence,
Md. Shakil Chowdhury +7 more
wiley +1 more source
E3S Web of Conferences, 2018 A new column of FRP composite tube confined steel-reinforced concrete (FTCSRC) column was proposed. This paper elaborates on laboratorial and analytical studies on the behavior of FCTSRC columns subjected to axial compressive load.
Wang Ji Zhong, Cheng Lu, Wang Xin Pei
doaj +1 more source
Characterisation Data - CFRP Composites
, 2022 modified-cfrp-composites-0714-wt ...
openaire +1 more source
Experimental determination of the multi-axial strain transfer from CFRP-laminates to embedded Bragg sensor [PDF]
, 2013 When embedded, optical fibre Bragg gratings are considered to be very valuable in terms of strain measurements of large composite structures for a number of reasons (safety rules, design criteria…).
Lammens, Nicolas
core +1 more source
, 2009 A conceptual design of an advanced Imaging Air Cherenkov Telescope with a 23 m diameter mirror and of 50 tons weight will be presented. A system photon detection efficiency of 15-17%, averaged over 300-600 nm, is aimed at to lower the threshold to 10-20 ...
Baixeras +6 more
core +1 more source
Polymer Composites, Volume 47, Issue 5, Page 4102-4126, 10 March 2026.Comparison of experimental and model‐predicted erosion rates for carbon fibre‐reinforced polymer (CFRP) and glass fibre‐reinforced polymer (GFRP) under low‐velocity (2 m/s) and at varying angles and sand concentrations (0.0, 0.05, 0.4 g/L). The results demonstrate good agreement between experimental data and model predictions across different erosive ...
Ali Al‐Darraji +4 more
wiley +1 more source