Results 81 to 90 of about 271,033 (300)

EXPERIENCE OF TREATMENT OF A PATIENT WITH POSTOPERATIVE PERINEAL HERNIA (CLINICAL CASE)

Медицина в Кузбассе, 2023
Chemical burn of the esophagus – local damage to the wall of the esophagus due to accidental or intentional ingestion of a chemical substance of cauterizing action through the mouth.
Татьяна Владимировна Мироненко, Орлан Валерийович Ооржак, Александр Карлович Лейсле, Татьяна Николаевна Хапаева, Евгений Владимирович Довбета, Александр Андреевич Харитонов, Светлана Ивановна Елгина, Вадим Гельевич Мозес, Елена Владимировна Рудаева, Кира Борисовна Мозес, Яэль Центер   +10 more
doaj  

Severe contact dermatitis induced by an unusual blend of pure henna

Archives of Clinical and Experimental Surgery, 2015
Henna is a natural dye extracted from Lawsonia inermis leaves and is commonly used all over the world to dye skin, hair and leather. Pure henna is rarely reported as a cause of contact dermatitis.
Halit Baykan, Kemal Ozyurt, Aysegul Baykan, Mehmet Ozkose, Hilmi Sen   +4 more
doaj   +1 more source

Application of mixing-controlled combustion models to gas turbine combustors [PDF]

Gas emissions were studied from a staged Rich Burn/Quick-Quench Mix/Lean Burn combustor were studied under test conditions encountered in High Speed Research engines.
Nguyen, Hung Lee
core   +1 more source

Underlying burning resistant mechanisms for titanium alloy

, 2018
The "titanium fire" as produced during high pressure and friction is the major failure scenario for aero-engines. To alleviate this issue, Ti-V-Cr and Ti-Cu-Al series burn resistant titanium alloys have been developed. However, which burn resistant alloy
Bo, Arixin, Chen, Yongnan, Gu, Yuantong, Wan, Mingpan, Yang, Wenqing, Zhan, Haifei, Zhang, Fengying, Zhao, Qinyang, Zhao, Yongqing   +8 more
core   +1 more source

Development of Sustainable MgO–C Refractories Using MgO–C Recyclates and a Novel Eco‐Friendly Fructose–Tannin Binder Crosslinked With Citric Acid

Advanced Engineering Materials, EarlyView.
This study develops sustainable MgO–C refractories using recycled materials and eco‐friendly fructose–tannin binders. The enhanced performance of citric acid as a cross‐linker and functional additives on mechanical and thermomechanical properties was examined. Characterization included strength tests, immersion trials, and microstructural and inclusion
Dinesh K. Gunasekar, Jana Hubálková, Steffen Dudczig, Gert Schmidt, Florian Kerber, Thomas Schemmel, Patrick Gehre, Christos G. Aneziris   +7 more
wiley   +1 more source

Feasibility study of launch vehicle ground cloud neutralization [PDF]

The distribution of hydrogen chloride in the cloud was analyzed as a function of launch pad geometry and rate of rise of the vehicle during the first 24 sec of burn in order to define neutralization requirements.
Kranyecz, T. E., Stoy, S. T., Vanderarend, P. C.   +2 more
core   +1 more source

Multifunctional Crushing and Piezoresistive Self‐Sensing in Conductive Epoxy/CNT‐Coated Polyetherimide TPMS Lattices

Advanced Engineering Materials, EarlyView.
This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay, J. Schneider, P. Harrison, S. Kumar   +3 more
wiley   +1 more source

Quantifying the impact of BOReal forest fires on Tropospheric oxidants over the Atlantic using Aircraft and Satellites (BORTAS) experiment: design, execution and science overview [PDF]

, 2013
We describe the design and execution of the BORTAS (Quantifying the impact of BOReal forest fires on Tropospheric oxidants over the Atlantic using Aircraft and Satellites) experiment, which has the overarching objective of understanding the chemical ...
Andrews, S., Aruffo, E., Bailey, L. J., Barrett, E., Bauguitte, S. J.-b., Bernath, P. F., Chisholm, L., Curry, K. R., Da Silva, A. M., Dan, L., Di Carlo, P., Duck, T. J., Forster, G., Franklin, J. E., Gibson, M. D., Griffin, D., Helmig, D., Hopkins, J. R., Hopper, J. T., Jenkin, M. E., Kindred, D., Kliever, J., Le Breton, M., Lee, J. D., Lewis, A. C., Matthiesen, S., Maurice, M., Moller, S., Moore, D. P., O'shea, S. J., Oram, D. E., Owen, R. C., Pagniello, C. M. L. S., Palmer, P. I., Parrington, M., Pawson, S., Percival, C. J., Pierce, J. R., Punjabi, S., Purvis, R. M., Remedios, J. J., Rickard, A. R., Rotermund, K. M., Sakamoto, K. M., Strawbridge, K. B., Strong, K., Tarasick, D. W., Taylor, J., Tereszchuk, K. A., Trigwell, R., Walker, K. A., Waugh, D. L., Weaver, D., Whaley, C., Young, J. C.   +54 more
core   +2 more sources

Impact of Pre‐Oxidation Treatments on a Recycled MgO/Steel‐Composite as Carbon Free Anode in Aluminum‐Electrolysis Environments

Advanced Engineering Materials, EarlyView.
Cermets (60 vol.% AISI 316L stainless steel, 40 vol.% recycled MgO), intended for use in aluminum electrolysis, were pre‐oxidized in three furnaces with different heating technologies and subjected to a cryolite corrosion test. The different atmospheres influenced the formation of oxide layers, which in turn affected corrosion resistance and ...
Patricia Kaiser, Felix Drechsler, Nora Brachhold, Florian Kerber, Christos G. Aneziris   +4 more
wiley   +1 more source

Barnes Hospital Bulletin [PDF]

, 1984
https://digitalcommons.wustl.edu/bjc_barnes_bulletin/1223/thumbnail ...

core   +1 more source