Results 131 to 140 of about 305,505 (331)
Advanced Functional Materials, EarlyView.A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source
First aid and emergency treatment after hydrofluoric acid splash
Zdravniški Vestnik, 2010 Introduction: Chemicals are used in all kinds of industry and one fifth of workers have dealt with dangerous chemicals. Hydrofluoric acid (HF) is one of the most dangerous inorganic acids; it is used in the electronics, chemical, glass, steel, car and ...
Miran Brvar +2 more
doaj
, 2011 The results of diffuse neutron scattering experiment on PbMg1/3Nb2/3O3 single crystal above the Burns temperature are reported. It is shown that the high temperature elastic diffuse component is highly anisotropic in low-symmetry Brillouin zones and this
A. I. Rudskoy +7 more
core +1 more source
Photo‐Switching Thermal and Lithium‐Ion Conductivity in Azobenzene Polymers
Advanced Functional Materials, EarlyView.Light‐responsive azobenzene polymers control thermal and ionic transport simultaneously through structural transitions. UV illumination disrupts π–π stacking, converting crystalline trans states to amorphous cis configurations. Thermal conductivity drops from 0.45 to 0.15 W·m−1·K−1 while Li+ diffusivity increases 100 fold. This dual transport switching
Jaeuk Sung +7 more
wiley +1 more source
Evaluation of the use of the late bougienage technique for chemical burns of the esophagus in children [PDF]
, 2023 Н. К. Барова +7 more
openalex +1 more source
Anomalous Stiffening of a Conjugated Polymer During Electrochemical Oxidation
Advanced Functional Materials, EarlyView.The electromechanical response of a thienothiophene‐based conjugated polymer with triethylene glycol side chains is investigated. Electrochemical nanoindentation and atomic force microscopy reveal a modest and reversible increase in elastic modulus at room temperature upon electrochemical oxidation.
Judith Pons i Tarrés +17 more
wiley +1 more source
Thermodynamic relations among isotropic material properties in conditions of plane shear stress
, 2018 We present new general relationships among the material properties of an isotropic material kept in homogeneous stress conditions with hydrostatic pressure and plane shear.
Calabrese, Salvatore +2 more
core +1 more source
Colloidal Crack Sintering Lithography for Light‐Induced Patterning of Particle Assemblies
Advanced Functional Materials, EarlyView.Colloidal crack sintering lithography (CCSL) is a microfabrication technique that uses light‐induced photothermal heating to trigger sintering and controlled cracking in polymer colloidal assemblies. Local structural changes generate microchannels and patterns, enabling direct writing of diverse topographic motifs.
Marius Schoettle +2 more
wiley +1 more source
Epidemiology of chemical burns: An 11-year retrospective study of 126 patients at a referral burn centre in the north of Iran. [PDF]
Int Wound J, 2023 Eftekhari H +7 more
europepmc +1 more source
Alkali Ion‐Incorporated HfO2 Dielectrics for Reconfigurable Neuromorphic Computing
Advanced Functional Materials, EarlyView.This work presents an indium gallium zinc oxide (IGZO) transistor with an alkali cation‐integrated hafnium dioxide (HfO2) dielectric exhibiting synaptic behavior via ion retention. The solution‐based film fabrication strategy overcomes the limitations of atomic layer deposition (ALD) and precursor coating, enabling the control of synaptic retention ...
Seung Yeon Ki +7 more
wiley +1 more source