Results 71 to 80 of about 126,760 (143)

A chopper current-feedback instrumentation amplifier with a 1 mHz 1/f noise corner and an AC-coupled ripple reduction loop

open access: yes, 2009
This paper presents a chopper instrumentation amplifier for interfacing precision thermistor bridges. For high CMRR and DC gain, the amplifier employs a three-stage current-feedback topology with nested-Miller compensation. By chopping both the input and
Wu, R. (author)   +2 more
core   +1 more source

Design of an SAR-Assisted Offset-Calibrated Chopper CFIA for High-Precision 4–20 mA Transmitter Front Ends

open access: yesApplied Sciences
In loop-powered 4–20 mA transmitter systems, sensors like temperature, pressure, flow, and gas sensors are chosen based on specific application requirements.
Jian Ren   +5 more
doaj   +1 more source

Design of a chopper-stabilized multipath operational amplifier

open access: yes
The main content of this work is the theoretical and practical design of the chosen topology of the chopper-stabilized operational amplifier. The introductory part of the diploma thesis focuses on the theory of noise, offset and drift.
Mrázek, Petr
core  

A 250 °C Low-Power, Low-Temperature-Drift Offset Chopper-Stabilized Operational Amplifier with an SC Notch Filter for High-Temperature Applications

open access: yesApplied Sciences
This paper proposes a three-stage op amp based on the SOI (silicon-on-insulator) process, which achieves a low offset voltage and temperature coefficient across a wide temperature range from −40 °C to 250 °C.
Zhong Yang   +5 more
doaj   +1 more source

A 35 nV/√Hz Analog Front-End Circuit with Adjustable Bandwidth and Gain in UMC 40 nm CMOS for Biopotential Signal Acquisition

open access: yesSensors
This paper presents a 35 nV/√Hz analog front-end (AFE) circuitdesigned in the UMC 40 nm CMOS technology for the acquisition of biopotential signal. The proposed AFE consists of a capacitive-coupled instrumentation amplifier (CCIA) and a combination of a ...
Lu Liu   +5 more
doaj   +1 more source

A chopper modulated low noise instrumentation amplifier for MEMS thermal sensors interfacing

open access: yes, 2011
A CMOS instrumentation amplifier for interfacing integrated thermal sensors is proposed. It is based on a Gm-C 2nd order low pass filter, and exploits chopper modulation to improve its performances in terms of offset and low frequency noise.
Massimo Piotto   +8 more
core   +1 more source

A 1.1uW 2.1uVrms Input Noise Chopper Amplifier for Biomedical Applications [PDF]

open access: yes, 2012
Thesis (Master's)--University of Washington, 2012Micropower amplifiers for neural sensing and other biosignals are becoming increasingly relevant in cutting edge biomedical research.
Mandic, Christopher John
core  

A Fast 650V Chopper Driver

open access: yes, 2010
In the framework of Linac4 and the Superconducting Proton Linac (SPL) studies at CERN, the design for a beam chopper has been carried out . This paper describes a new chopper driver amplifier providing 650 V on 50 Ω with fronts of about 2 ns and a ...
Paoluzzi, Mauro
core  

A Capacitively-Coupled Chopper Instrumentation Amplifier for Implantable Bridge Sensor Systems

open access: yes
This paper presents an energy and area efficient capacitively-coupled chopper instrumentation amplifier (CCIA) dedicated to implantable bridge sensor systems. Chopper stabilization is employed to decrease its offset and 1/f noise and the resulting ripple
Beghetti, Maurice   +5 more
core   +1 more source

49Design of Low 1 /f Noise Folded Cascode Operational Amplifier by Using Chopper Stabilization Technique [PDF]

open access: yes
Biological signals have low voltage and low frequency. Very low noise, high gain, fast speed and stable amplifier are necessary to process these signals.
タンノ, コウイチ   +3 more
core   +1 more source

Home - About - Disclaimer - Privacy