Results 231 to 240 of about 297,887 (290)
Some of the next articles are maybe not open access.
Optimization of chopper amplifiers for speed and gain
IEEE Journal of Solid-State Circuits, 1994This paper presents design techniques to optimize the performance of chopper-stabilized ac-coupled CMOS inverter amplifiers. These amplifiers are used as comparators in highspeed flash analog-to-digital converters. For any given process technology, as the required conversion speed and resolution are increased, the amplifiers are required to increase ...
openaire +1 more source
International Symposium on Circuits and Systems, 2021
This paper presents a high-precision and energy-efficiency Capacitively-coupled Chopper Instrumentation amplifier (CCIA) for Wheatstone bridges readout. The Ripple Reduction Loop (RRL) structure is improved to enhance the attenuation effect. In addition,
Hua-Ping Chen, Lei Zhang, Yan Wang
semanticscholar +1 more source
This paper presents a high-precision and energy-efficiency Capacitively-coupled Chopper Instrumentation amplifier (CCIA) for Wheatstone bridges readout. The Ripple Reduction Loop (RRL) structure is improved to enhance the attenuation effect. In addition,
Hua-Ping Chen, Lei Zhang, Yan Wang
semanticscholar +1 more source
Measurement and Analysis of Current Noise in Chopper Amplifiers
IEEE Journal of Solid-State Circuits, 2013This paper presents a theoretical analysis and measurements of the current noise of several chopper instrumentation amplifiers, which demonstrate that the charge injection and clock feed-through associated with the MOSFETs of the input chopper give rise to significant input current and current noise.
Jiawei Xu 0001 +5 more
openaire +1 more source
Capacitively-coupled Chopper Instrumentation Amplifiers: An Overview
2018 IEEE SENSORS, 2018Capacitively-coupled chopper instrumentation amplifiers (CCIAs) have attracted plenty of attention in the past decade. They offer micro-volt offset, low 1/f noise, high noise efficiency and excellent rejection/isolation of input common-mode voltages. As such they are increasingly used in low power precision sensor interfaces, as well as in biomedical ...
Qinwen Fan, Kofi A. A. Makinwa
openaire +1 more source
IEEE Solid-State Circuits Letters, 2023
This letter presents a chopper-stabilized multipath operational amplifier (OPA). By utilizing a 7-bit MOS-DAC-based offset calibration along with a passive ripple reduction filter, the OPA achieves a low input ripple in a power-efficient manner.
Tianxiang Qu +4 more
semanticscholar +1 more source
This letter presents a chopper-stabilized multipath operational amplifier (OPA). By utilizing a 7-bit MOS-DAC-based offset calibration along with a passive ripple reduction filter, the OPA achieves a low input ripple in a power-efficient manner.
Tianxiang Qu +4 more
semanticscholar +1 more source
Chopper Amplifier [Circuit Intuitions]
IEEE Solid-State Circuits Magazine, 2016Welcome to the ninth article in this column series. As the title suggests, each article provides insights and intuitions into circuit design and analysis. These articles are aimed at undergraduate students but may serve the interests of other readers as well.
openaire +1 more source
A Fill-In Technique for Robust IMD Suppression in Chopper Amplifiers
IEEE Journal of Solid-State Circuits, 2021In chopper amplifiers, the interaction between the input signal and the chopper clock can give rise to intermodulation distortion (IMD). This chopper-induced IMD is mainly due to amplifier delay, which causes large pulses at the output of the amplifier's output chopper.
Thije Rooijers +4 more
openaire +3 more sources
A fully integrated CMOS chopper amplifier
[1991] Proceedings Fourth Annual IEEE International ASIC Conference and Exhibit, 2002A CMOS chopper amplifier that achieves reduced input offset voltage and fast overload recovery time while maintaining bandwidths comparable to conventional operational amplifiers and requiring no external components is presented. The chopper amplifier consists of two folded cascode operational transconductance amplifiers (OTA) connected in a switched ...
D. Garrity, J. Young, D. Thelen
openaire +1 more source
Design of a Constant-Gm Rail-to-Rail Operational Amplifier with Chopper Stabilization
2025 5th International Conference on Electronics, Circuits and Information Engineering (ECIE)In order to improve the detection accuracy of current singal, a low offset, input/output rail-to-rail operational amplifier is proposed. To ensure that the transconductance of the input stage is constant in the entire common-mode range, the operational ...
Yinuo Hao, Senlin He, Peilei Xiao
semanticscholar +1 more source
CMOS chopper amplifier for chemical sensor
[1991] Conference Record. IEEE Instrumentation and Measurement Technology Conference, 1992A highly sensitive CMOS chopper amplifier used for an oxygen probe is described. It is integrated in a 2- mu m double-poly p-well CMOS process. The chip uses only a single 5-V voltage source, and no external components are needed. It is realized by a current mode chopper technique in order to overcome the low-frequency noise and drift problems.
S.-J. Wei, H.C. Lin
openaire +1 more source