Results 211 to 220 of about 299,019 (288)

Noise Analysis and Simulation of Chopper Amplifier [PDF]

open access: possibleAPCCAS 2006 - 2006 IEEE Asia Pacific Conference on Circuits and Systems, 2006
Conventional SPICE-like simulators are not adequate for the noise simulation of the chopper amplifier, which typically has no DC operating point. This paper discusses the noise properties of the chopper amplifier in both time domain and frequency domain and presents a method of simulating chopper amplifier noise behavior with the RF simulator?SpectreRF.
Tao Yin   +3 more
openaire   +2 more sources

A 1.8GΩ-Input-Impedance 0.15µV-Input-Referred-Ripple Chopper Amplifier with Local Positive Feedback and SAR-Assisted Ripple Reduction

IEEE Custom Integrated Circuits Conference, 2022
Many sensors exhibit output impedances greater than a few MΩ, and the subsequent instrumentation amplifier (IA) must be carefully designed to meet the requirements of high input impedance $(\mathrm{R}_{\text{in}})$, low noise and low offset.
Tianxiang Qu   +4 more
semanticscholar   +1 more source

A Chopper Amplifier with Low Offset and Low Noise for Temperature Controllers

International Conference on Information Communication and Management, 2022
For high precision integrated temperature controllers, the low frequency noise and offset voltage will affect the accuracy. The chopper stabilization technology can eliminate the offset and 1/f noise through modulation, transfer and filtering signal ...
Yifan Hu   +4 more
semanticscholar   +1 more source

A 1.9 µW 127 n V/ √Hz Bio Chopper Amplifier Using a Noise-Efficient Common Mode Cancelation Loop

International Conference on Autonomic and Trusted Computing, 2022
Electrical neural stimulation (ENS) is widely used for implantable applications to convey information to nervous tissue. However, ENS will generate large common (CM) artifacts at the electrode tissue, leading to saturate the traditional biopotential ...
Xuan Thanh Pham   +5 more
semanticscholar   +1 more source

Analysis of a Chopper Amplifier [PDF]

open access: possibleIETE Journal of Research, 1970
Choppers are often required for obtaining low drift performance of low level d.c. amplifiers. The chopper amplifier basically consists of a modulator, an a.c. amplifier, a synchronous demodulator and a low pass filter. The drift-free performance results from the use of the ‘drift-less’ a.c. amplifier for amplification.The a.c.
openaire   +1 more source

Low-Noise Chopper Amplifier Using Lateral PNP Input Stage With Automatic Base Current Cancellation

IEEE Transactions on Circuits and Systems - II - Express Briefs, 2021
This brief presents a low-noise chopper amplifier that uses a lateral PNP input stage with automatic base current cancellation in complementary metal–oxide–semiconductor (CMOS) process.
Hyungseup Kim   +8 more
semanticscholar   +1 more source

A 4.5 GΩ-Input Impedance Chopper Amplifier With Embedded DC-Servo and Ripple Reduction Loops for Impedance Boosting to Sub-Hz

IEEE Transactions on Circuits and Systems - II - Express Briefs, 2021
Achieving a high input impedance ${Z} _{\mathrm{ in}}$ is important for the instrumentation amplifier (IA) performing neural and biopotential signal sensing.
Xuan Thanh Pham   +4 more
semanticscholar   +1 more source

Design of CMOS Analog Front-End Local-Field Potential Chopper Amplifier With Stimulation Artifact Tolerance for Real-Time Closed-Loop Deep Brain Stimulation SoC Applications

IEEE Transactions on Biomedical Circuits and Systems
A CMOS analog front-end (AFE) local-field potential (LFP) chopper amplifier with stimulation artifact tolerance, improved right-leg driven (RLD) circuit, and improved auxiliary path is proposed. In the proposed CMOS AFE LFP chopper amplifier, common-mode
Chung-Yu Wu   +5 more
semanticscholar   +1 more source

A chopper dc instrumental amplifier

Measurement Techniques, 1987
Because of their low zero drift chopper, dc amplifiers [I, pp. 22-23] are widely used in measuring equipment. The ratio of the maximum cut-off frequency of such an amplifier to its modulation frequency must be carefully chosen since an increase of its carrier frequency magnifies the effect of high-frequency pulse noise on the output voltage [2] in ...
A. E. Gudilin, S. V. Zhmak
openaire   +1 more source

A 46.6 μg/√Hz Single-Chip Accelerometer Exploiting a DTC-Assisted Chopper Amplifier

IEEE Journal of Solid-State Circuits
This article presents a single-chip accelerometer with the best reported thermal noise and the lowest bias instability among state-of-the-art accelerometers with high- $g$ ( $>$ 1000 $g$ ) sensing capability.
Xiaoliang Li   +5 more
semanticscholar   +1 more source

Home - About - Disclaimer - Privacy