Results 11 to 20 of about 299,019 (288)
Ultralow-Noise Chopper Amplifier for Seafloor E-Field Measurement [PDF]
SensorsThe seafloor E-field signal is extremely weak and difficult to measured, even with a high signal-to-noise ratio. The preamplifier for electrodes is a key technology for ocean-bottom electromagnetic receivers.
Sixuan Song, Kai Chen
exaly +5 more sources
A chopper amplifier with adaptive biasing OTA for biomedical applications, featuring high gain and CMRR. [PDF]
PLoS ONEThis paper presents a design of fully differential chopper amplifier employing the flipped voltage follower (FVF) adaptive biasing technique, focusing on its potential use in biopotential recording applications.
Bhaskara Rao Kasipogula +1 more
doaj +3 more sources
Novel Tunable Pseudoresistor-Based Chopper-Stabilized Capacitively Coupled Amplifier and Its Machine Learning-Based Application [PDF]
MicromachinesThis work presents a high-common-mode-rejection-ratio (CMRR) and high-gain FinFET-based bio-potential amplifier with a novel CMRR reduction technique. In this paper, a feedback buffer is used alongside a capacitively coupled chopper-stabilized circuit to
Mohammad Aleem Farshori +8 more
doaj +3 more sources
A Compact Low-Power Chopper Low Noise Amplifier for High Density Neural Front-Ends [PDF]
SensorsThis paper presents a low-power and area-efficient chopper-stabilized low noise amplifier (CS-LNA) for in-pixel neural recording systems. The proposed CS-LNA can be used in a multi-channel architecture, in which the chopper mixers of the LNA are ...
Alessandro Fava +3 more
doaj +3 more sources
Design of a 0.5 V Chopper-Stabilized Differential Difference Amplifier for Analog Signal Processing Applications [PDF]
Sensors, 2023 This paper presents a low-voltage low-power chopper-stabilized differential difference amplifier (DDA) realized using 40 nm CMOS technology. Operating with a supply voltage of 0.5 V, a three-stage DDA has been employed to achieve an open-loop gain of 89 ...
Pak Kwong Chan, Xinlan Fan
exaly +4 more sources
Journal of Low Power Electronics and ApplicationsChopper and capacitively coupled techniques are employed in instrumentation amplifiers to create capacitively coupled chopper instrumentation amplifiers (CCIAs) that obtain a high noise power efficiency.
Xuan Thanh Pham, Kha Hoang
exaly +4 more sources
Applied Sciences (Switzerland), 2020 This paper proposes a low noise readout integrated circuit (IC) with a chopper-stabilized multipath operational amplifier suitable for a Wheatstone bridge sensor.
Hyoungho Ko +2 more
exaly +3 more sources
IEEE Journal of the Electron Devices SocietyIn this paper, a new architecture for glucose biosensors is proposed, which adopts a Chopper amplifier instead of a conventional instrumentation amplifier (INA) and differential extended gate field effect transistor (EGFET) as the input stage.
Po-Yu Kuo +10 more
doaj +2 more sources
Low-noise chopper amplifier design for low-frequency induction magnetometers
Journal of Geophysics and Engineering, 2023 Induction Magnetometers (IM) are commonly used in Magnetotelluric Method for exploration. 1/f noise in the low frequency band of the preamplifier reduce the signal-to-noise ratio of IM, thus affecting the exploration results.
Yao Tang
exaly +2 more sources
EngIn this paper, a high-voltage chopper and ping-pong auto-zeroing operational amplifier was designed for industrial and automotive applications. Based on chopper stabilization, the proposed circuit introduces a novel chopper switch control signal that ...
Guolong Li +5 more
doaj +2 more sources