Results 131 to 140 of about 124,127 (185)
Noise Analysis and Simulation of Chopper Amplifier [PDF]
APCCAS 2006 - 2006 IEEE Asia Pacific Conference on Circuits and Systems, 2006 Conventional SPICE-like simulators are not adequate for the noise simulation of the chopper amplifier, which typically has no DC operating point. This paper discusses the noise properties of the chopper amplifier in both time domain and frequency domain and presents a method of simulating chopper amplifier noise behavior with the RF simulator?SpectreRF.
Tao Yin +3 more
openaire +2 more sources
IEEE Transactions on Circuits and Systems II: Express Briefs, 2017 This brief presents the design of a low-noise chopper capacitively coupled instrumentation amplifier (CCIA). To accommodate the input with large electrode offset (EOS), the amplifier includes a coarse digital dc-servo loop (DSL) in addition to a fine ...
Jiawei Zheng +2 more
exaly +2 more sources
Analysis of a Chopper Amplifier [PDF]
IETE Journal of Research, 1970 Choppers are often required for obtaining low drift performance of low level d.c. amplifiers. The chopper amplifier basically consists of a modulator, an a.c. amplifier, a synchronous demodulator and a low pass filter. The drift-free performance results from the use of the ‘drift-less’ a.c. amplifier for amplification.The a.c.
openaire +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Measurement and Analysis of Current Noise in Chopper Amplifiers
IEEE Journal of Solid-State Circuits, 2013This paper presents a theoretical analysis and measurements of the current noise of several chopper instrumentation amplifiers, which demonstrate that the charge injection and clock feed-through associated with the MOSFETs of the input chopper give rise to significant input current and current noise.
Kofi A. A. Makinwa +2 more
exaly +3 more sources
A chopper dc instrumental amplifier
Measurement Techniques, 1987Because of their low zero drift chopper, dc amplifiers [I, pp. 22-23] are widely used in measuring equipment. The ratio of the maximum cut-off frequency of such an amplifier to its modulation frequency must be carefully chosen since an increase of its carrier frequency magnifies the effect of high-frequency pulse noise on the output voltage [2] in ...
A. E. Gudilin, S. V. Zhmak
openaire +1 more source
A Chopper Instrumentation Amplifier with Amplifier Slicing Technique for Offset Reduction
2020 IEEE International Symposium on Circuits and Systems (ISCAS), 2020This paper presents a chopper instrumentation amplifier design that employs a proposed amplifier slicing technique for offset reduction. In this scheme, the core amplifier is split into multiple identical slices. During operation, the offset polarity of these slices is firstly determined by employing the second-stage of the amplifier as a static ...
Tsz Ngai Lin +3 more
openaire +2 more sources
A sensitive superconducting “chopper” amplifier
Physica, 1957Synopsis A superconducting “chopper” amplifier without movable parts and possessing a direct current sensitivity better than 10−11 volt is described. Compactness of cryostat equipment and convenience of observation were factors controlling design.
A.R. De Vroomen, C. Van Baarle
openaire +1 more source
Current Noise of Chopper Amplifiers
2018This chapter investigates the root cause of 1/f2 noise of chopper amplifiers through a theoretical analysis and measurements of several chopper IAs. It is well known that the charge injection and clock feedthrough associated with the MOSFETs of the input chopper give rise to significant input current and current noise, which may then be a significant ...
Jiawei Xu +3 more
openaire +1 more source
Optimization of chopper amplifiers for speed and gain
IEEE Journal of Solid-State Circuits, 1994This paper presents design techniques to optimize the performance of chopper-stabilized ac-coupled CMOS inverter amplifiers. These amplifiers are used as comparators in highspeed flash analog-to-digital converters. For any given process technology, as the required conversion speed and resolution are increased, the amplifiers are required to increase ...
openaire +2 more sources
Low power chopper amplifier without LPF
2010 IEEE Asia Pacific Conference on Circuits and Systems, 2010Chopping technique is an efficient approach to decrease the 1/f noise and low-frequency offset of CMOS amplifiers, but conventional chopper amplifier consumes large power because it required a wide-band amplifier exceed a chopping frequency and a post low pass filter (LPF) for eliminating modulation noise.
Xiao Yang +3 more
openaire +3 more sources