Results 131 to 140 of about 103,193 (347)
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
A 24-GHz, +14.5-dBm fully integrated power amplifier in 0.18-μm CMOS [PDF]
A 24-GHz +14.5-dBm fully integrated power amplifier with on-chip 50-[ohm] input and output matching is demonstrated in 0.18-μm CMOS. The use of substrate-shielded coplanar waveguide structures for matching networks results in low passive loss and small ...
Hajimiri, Ali +2 more
core
ZnS‐MXene‐TiO2 nanocomposite heterojunction for photocatalytic decomposition of this methylene blue dye (MB) greatly improves light absorption, charge separation, and active site area. Two‐dimensional MXene forms nanocomposites by easily combining them with 0D (quantum dots), 1D (tube and wire), 2D (plane and sheet), and 3D (particle and lamellar ...
Latiful Kabir +7 more
wiley +1 more source
Amplifier‐Based Programmable Metasurface for Bidirectional Full Polarization Enhancement
Electromagnetic waves emitted by a transmitter in practical scenarios are often degraded by obstacles along the transmission path, polarization mismatch, and distance to the receiver, which significantly limits the quality of wireless communication.
Xin Wang +5 more
doaj +1 more source
A 5-GHz Class-E power amplifier with an Inverse Class-B driver on 65nm CMOS [PDF]
Matthew Love +2 more
openalex +1 more source
A 55 nm CMOS RF Transmitter Front-End with an Active Mixer and a Class-E Power Amplifier for 433 MHz ISM Band Applications [PDF]
Huazhong Yuan +4 more
openalex +1 more source
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source
This study demonstrates how optimizing laser power, scanning speed, and hatching distance in laser powder bed fusion can boost the productivity of Inconel 718 manufacturing by up to 29% while maintaining mechanical integrity. The work delivers a validated process window and cost–time analysis, offering industry‐ready guidelines for efficient additive ...
Amir Behjat +7 more
wiley +1 more source
Quantum, cyclic and particle-exchange heat engines
Differences between the thermodynamic behavior of the three-level amplifier (a quantum heat engine based on a thermally pumped laser) and the classical Carnot cycle are usually attributed to the essentially quantum or discrete nature of the former.
Allahverdyan +33 more
core +1 more source

