Results 141 to 150 of about 7,429 (251)
Parameter identification and hybrid mathematical modelling techniques applied to non-linear control systems [PDF]
The study is concerned with the mathematical modelling and parameter identification of nonlinear motion control systems. The control systems under review are the axis motion control systems for a 3-axis CNC machine tool.
Pislaru, Crinela
core
Polymer Composites, Volume 47, Issue S2, Page S733-S749, 20 June 2026.Graphical abstract illustrating the experimental design and key findings of the study. ABSTRACT Basalt fiber‐reinforced polymer (BFRP) composites are gaining attention as sustainable alternatives to conventional fiber‐reinforced polymers owing to their favorable mechanical properties and environmental advantages.
Abdulrahman Adeiza Musa +7 more
wiley +1 more source
Polymer Composites, Volume 47, Issue 12, Page 11517-11528, 20 June 2026.Mechanical Property Enhancement and 21% Density Reduction in CNC‐Reinforced Glass Fiber Composites. ABSTRACT The use of cellulose nanocrystals (CNCs) as a sustainable, high‐performance alternative to partially replace calcium carbonate (CaCO3) in polyester sheet molding compound (SMC) composites is investigated.
Kim Anh Pham +3 more
wiley +1 more source
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
Advanced Engineering Materials, Volume 28, Issue 12, 17 June 2026.This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, Volume 28, Issue 12, 17 June 2026.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Development of modular machine tool structural monitoring system [PDF]
Although designed to be structurally stiff, machine tool deformation takes place due to the various sources of errors such as shifting mass, component weight, temperature etc.
Longstaff, Andrew P. +3 more
core
New optical sensing system applied to taut wire based straightness measurement [PDF]
In modern manufacturing industry, precision components are typically produced on Computer Numerical Controlled (CNC) machine tools which translate their accuracy onto machined parts. This accuracy is affected by a set of different motion errors caused by
Borisov, Oleg
core
A Low-Cost Vision-Based Monitoring of Computer Numerical Control (CNC) Machine Tools for Small and Medium-Sized Enterprises (SMEs). [PDF]
Sensors (Basel), 2019 Kim H, Jung WK, Choi IG, Ahn SH.
europepmc +1 more source
A Knowledge-Driven Approach for 3D High Temporal-Spatial Measurement of an Arbitrary Contouring Error of CNC Machine Tools Using Monocular Vision. [PDF]
Sensors (Basel), 2019 Li X, Liu W, Pan Y, Ma J, Wang F.
europepmc +1 more source
TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 1994 Nakao, Yohichi +2 more
openaire +2 more sources