Results 151 to 160 of about 101,853 (203)
Some of the next articles are maybe not open access.
Micro-Stress Transfer of CNT and CNT-Interface in CNT Reinforced Mg-Matrix Composites
Advanced Materials Research, 2011The aim of the present paper is that, utilizing finite element method, considering the influence of different length of CNTs and different strength of interface to investigate the micro stress distribution of CNT reinforced magnesium matrix composite. When analyzing, the material character of magnesium is regarded as anisotropic.
Li Qing, Yu Chao
openaire +1 more source
Effect of CNT length and CNT-matrix interphase in carbon nanotube (CNT) reinforced composites
Mechanics Research Communications, 2005zbMATH Open Web Interface contents unavailable due to conflicting licenses.
Wan, H., Delale, F., Shen, L.
openaire +1 more source
Fabrication and characterization of Fe3O4/CNTs and Fe2N/CNTs composites
Journal of Electroceramics, 2006By controlling the nitridation temperature, magnetic nanoparticles (Fe3O4and Fe2N) were attached to the carbon nanotubes (CNTs) to fabricate new Fe3O4/CNTs and Fe2N/CNTs composites with magnetic property from the same precursor. The attachment of tiny magnetic nanoparticles on CNTs is crucial for the formation of a homogeneous composite, which provides
Linqin Jiang, Lian Gao
openaire +1 more source
The influence of CNTs on the thermoelectric properties of a CNT/Bi2Te3 composite
Carbon, 2013Abstract CNT/Bi 2 Te 3 composites were prepared from composite powders in which CNTs were implanted in the Bi 2 Te 3 matrix powders by a novel chemical route. It was found that the fabricated composite had a microstructure of a homogeneous dispersion of CNTs in the Bi 2 Te 3 matrix due to interfacial bonding agents of oxygen atoms attaching to the
CHOI, SI YOUNG +6 more
openaire +2 more sources
Heat Dissipation Mechanism at Supported CNT-CNT Junctions
Volume 1: Heat Transfer in Energy Systems; Theory and Fundamental Research; Aerospace Heat Transfer; Gas Turbine Heat Transfer; Transport Phenomena in Materials Processing and Manufacturing; Heat and, 2012The thermal transport at the carbon nanotube (CNT) interfaces such as CNT-oxide and CNT-CNT junctions can significantly impact the device performance and reliability of nanotube network based thin-film transistors. For an example, the high electrical and thermal resistance at CNT junctions can cause hot spots, inefficient heat removal or even breakdown
Satish Kumar, Liang Chen
openaire +1 more source
CNTs and CNT/ZnO nanostructures for use as electron sources
2010 8th International Vacuum Electron Sources Conference and Nanocarbon, 2010The paper presents the growth and optimization of carbon nanotube (CNT) and CNT/zinc oxide nanostructures to produce novel electron sources. The emitters studied in this project are based on regular array of vertically aligned 5 μm height and 50 nm diameter CNTs with a pitch of 10 μm.
W.I. Milne +8 more
openaire +1 more source
Effect of functionalisation of CNT in the preparation of HAp–CNT biocomposites
Ceramics International, 2015Hydroxyapatite (HAp)–carbon nanotube (CNT) composites are being fabricated, where CNT acts as a reinforcement in the ceramic matrix. CNT improves the mechanical property of HAp and offers a potential implant material used for orthopaedic applications.
Susmita Mukherjee +3 more
openaire +1 more source
2020
The chapter will start with brief introduction to the interconnects and its importance in an integrated circuit at deep sub-micron technology nodes. The brief discussion about the concept of scaling, interconnects models, and material in use are presented. The limitations of conventional materials at scaled down technology nodes will be discussed next.
openaire +1 more source
The chapter will start with brief introduction to the interconnects and its importance in an integrated circuit at deep sub-micron technology nodes. The brief discussion about the concept of scaling, interconnects models, and material in use are presented. The limitations of conventional materials at scaled down technology nodes will be discussed next.
openaire +1 more source
Effective Dispersion of CNTs to Fabricate CNT/Mg Nanocomposite
Materials Science Forum, 2015An effective dispersion process to cast CNT-reinforced in a concentrated magnesium alloy (AZ31) nanocomposite was investigated in this study. The metal magnesium powder was first coated with dispersed CNTs by wet process, followed by the fabricating of CNT/Mg precursor using mechanical briquetting and extrusion.
Guo Qiang Han +5 more
openaire +1 more source
Influence of CNT Diameter and Annealing on the Tensile Property of CNT by Using Untwisted CNT Yarn
The Proceedings of the Materials and Mechanics Conference, 2022Yoshinobu SHIMAMURA +3 more
openaire +1 more source