Results 51 to 60 of about 5,615,470 (227)

Estimation of Aperture and Stiffness of Fractures under High Water Pressure Using Hydrological Data and Slurry Consolidating Body

Geofluids, 2022
The fractured limestone aquifers under coal seams bring great threat to coal production, and grouting engineering before mining is usually used to seal the fractures and prevent water inrushes.
Jianbo Li, Yanchun Xu
doaj   +1 more source

Study on the composite fracture characteristics of filling and reinforcing cracked rock mass after high temperature damage

Deep Underground Science and Engineering, EarlyView.
Cement infill shares compressive and shear stresses during loading, while interfacial friction hinders crack propagation and reduces stress concentration, improving the rock's load‐bearing capacity. Failure modes vary with crack inclination. Unfilled specimens show four modes.
Shihao Yuan, Qiang Sun, Jianjun Hu, Liwei Zhang, Jishi Geng   +4 more
wiley   +1 more source

Carbon emission assessment of tunnel infrastructures: From construction to operation

Deep Underground Science and Engineering, EarlyView.
This study develops a lifecycle carbon accounting framework for tunnel infrastructures, covering design, construction, operation, maintenance, and dismantling. Applied to a subsea tunnel case, the framework reveals the carbon emission distribution among four typical tunnel types and highlights potential carbon offset methods for low‐carbon tunnel ...
Luyuan Long, Wout Broere, Xuehui Zhang, Tian Xia, Richard de Nijs   +4 more
wiley   +1 more source

Uniaxial compressive strength prediction and ratio parameter optimization of titanium tailings composite backfill materials using intelligent hybrid models

Deep Underground Science and Engineering, EarlyView.
Based on the 90 datasets, ERT and four optimization algorithms were used to build four hybrid models to predict the UCS of the backfill body. The SMA‐ERT model was the most effective model, and it can reliably guide the design of the backfill ratio parameters. Abstract This study analyzed the feasibility of using titanium (Ti) tailings as a backfilling
Weijun Liu, Zida Liu, Zhixiang Liu
wiley   +1 more source

Experimental Study on Water Reduction Modification and Efficient Utilization of Coal-Based Solid Waste Slurry

Advances in Civil Engineering
Unreasonable treatment of coal-based solid waste and coal mining damage are important factors that cause negative environmental effects. Overburden isolated grouting, a green mining method, can realize solid waste emission reduction and coal mine ...
Chengwei Ma, Dayang Xuan, Jialin Xu, Jian Li   +3 more
doaj   +1 more source

Fabrication and Preparation of Coal-Water Slurry Dispersant with Amphoteric Polycarboxylate

, 2011
Coal-water slurry （CWS）dispersant is a key to prepare fine coal-water slurry. A novel amphoteric polycarboxylic (AmPC) dispersant for CWS was copolymerized in aqueous solution by comonomers methacrylate polyglycol monoester (PA), propylene sulfur sodium (
Zhuo Miao, Guang Hua Zhang, Jun Feng Zhu, Hao Hao   +3 more
core   +1 more source

Recovery and Repurposing of End‐of‐Life Graphitic Anodes for Green Lithium‐Ion Batteries

EcoEnergy, EarlyView.
This review summarizes the degradation mechanisms of spent graphite anodes in lithium‐ion batteries and highlights key recycling, regeneration, and modification strategies, including hydrometallurgical and pyrometallurgical approaches. It also discusses recent advances in surface engineering, structural regulation, and material hybridization, offering ...
Wei Wei, Weiguo Liu, Jiangqi Zhou
wiley   +1 more source

Design of Atomizers and Burners for Coal-Water Slurry Combustion [PDF]

, 1998
The Falling Droplet device was used to measure the extensional viscosity of a variety of aqueous polymer solutions. These solutions were atomized with the miniature ''inverse'' twin-fluid atomizer. Droplet size measurements were made with a Malvern laser diffraction particle sizing device.
Chigier, Norman, Hitron, Rony, Humphrey, William   +2 more
openaire   +6 more sources

Hydride Materials for Advanced Electrochemical Energy Storage: Progress and Perspectives

EcoEnergy, EarlyView.
Hydrides are emerging as functional materials for low‐carbon electrochemical energy storage. Complex hydrides provide polyanionic electrolyte frameworks for all‐solid‐state, Li–S, and multivalent batteries; hydride ion conductors enable H− transport for emerging hydride‐based cells; and metal hydrides offer established electrode chemistries for Ni–MH ...
Taehyun Kim, Taegyoung Lee, Huijeong Oh, Shin‐ichi Orimo, Sangryun Kim   +4 more
wiley   +1 more source

Application and prospect of coal gangue slurry filling technology

Meitan kexue jishu
In order to realize in-situ, green and large-scale disposal of coal gangue, coal gangue slurry filling technology, as a new filling technology, has been rapidly developed and applied in recent years.
Lei ZHU, Wenzhe GU, Chaofeng YUAN, Chengyong LIU, Hao PAN, Tianqi SONG, Fengtian SHENG   +6 more
doaj   +1 more source