Finite element modelling of cold formed stainless steel columns [PDF]
, 2004 This paper describes the results obtained from a finite element investigation into the load capacity of column members of lipped channel cross-section, cold formed from Type 304 stainless steel, subjected to concentric and eccentric compression loading ...
Rhodes, J., Macdonald, M.
core +5 more sources
Web crippling behaviour of cold-formed steel channel sections with offset web holes subjected to interior-two-flange loading [PDF]
, 2012 Cold-formed steel sections are often used as wall studs or floor joists; such sections often include web holes for ease of installation of the services. Cold-formed steel design codes, however, do not consider the effect of such web holes. In this paper,
Uzzaman, Assraf +17 more
core +4 more sources
Pyogenic Granuloma of the Lower Airway- A Systematic Review [PDF]
Journal of Clinical and Diagnostic Research, 2022 Introduction: Pyogenic granulomas (PGs) are benign lesions that are very common in the upper aerodigestive tract. These lesions occur due to hormonal imbalance or due to a predisposing traumatic factor.
VM Lakshana Deve +5 more
doaj +1 more source
Numerical investigation of cold-formed steel top-hat purlins [PDF]
, 2014 This paper considers the use of cold-formed steel top-hat sections for purlins as an alternative to conventional zed-sections. The use of such top-hat sections may be viable for use in cold-formed steel portal framing systems, where both the frame ...
Wrzesien, Andrzej +4 more
core +3 more sources
Cold-formed steel sections with web openings subjected to web crippling under two-flange loading conditions — Part II : Parametric study and proposed design equations [PDF]
, 2012 A parametric study of cold-formed steel sections with web openings subjected to web crippling was undertaken using finite element analysis, to investigate the effects of web holes and cross-section sizes on the web crippling strengths of channel sections
Uzzaman, Asraf +4 more
core +4 more sources
Coblation Versus Cold Steel Tonsillectomy: Prospective Comparative observational study [PDF]
Basrah Journal of SurgeryBackground: Coblation tonsillectomy is a relatively recently introduced surgical technique which attempts to bridge the gap between hot and cold tonsillectomy methods.
Ahmed Alansary +2 more
doaj +1 more source
Synchrotron strain scanning for residual stress measurement in cold-drawn steel rods [PDF]
, 2011 Cold-drawn steel rods and wires retain significant residual stresses as a consequence of the manufacturing process. These residual stresses are known to be detrimental for the mechanical properties of the wires and their durability in aggressive ...
M Elices +5 more
core +1 more source
International Archives of Otorhinolaryngology, 2023 Introduction Tonsillectomy is among the most common otolaryngological surgeries.
Süheyla Kandemir +3 more
doaj +1 more source
Electrocautery versus cold steel tonsillectomy comparison study
مجله كليه طب الكندي, 2019 Objective: the objective of this study was to compare the intraoperative blood loss, intraoperative time, postoperative pain and secondary hemorrhage between electrodissection and cold steel dissection tonsillectomy.
Firas Baheej Abdul Aema
doaj +1 more source
Comparative Evaluation of Cold Dissection (Suture vs. Ligation) and Hot Dissection Tonsillectomy in Children: Postoperative Pain, Bleeding, and Operative Time [PDF]
Journal of Clinical MedicineBerkay Guzel
exaly +2 more sources