Results 41 to 50 of about 483,608 (187)
High-Temperature SHS Heat Insulators Based on Pre-Activated Mineral Raw Materials
In this paper, the results of the technological combustion of SHS heat insulators based on mineral origins are presented. It is shown that after mechanochemical treatment of minerals—diatomite—the kinetic characteristics of the combustion process change,
Bakhtiyar Sadykov +6 more
doaj +1 more source
Copper smelting dust is a heterogeneous by-product of pyrometallurgical processing containing sulfate- and arsenic-bearing components, which accounts for its high chemical stability and environmental hazard. In this context, mechanochemical activation is
Timur Osserov +3 more
doaj +1 more source
A study on the relationship between vehicle operating conditions and NOx emission characteristics [PDF]
To address the challenges faced by vehicles during actual operation when passing through traffic lights or intersections, where rapid changes in operating conditions can lead to a decrease in SCR efficiency and an increase in NOx emissions, this study ...
Xia Ran +4 more
doaj +1 more source
AbstractCombustion noise is becoming increasingly important as a major noise source in aeroengines and ground based gas turbines. This is partially because advances in design have reduced the other noise sources, and partially because next generation combustion modes burn more unsteadily, resulting in increased external noise from the combustion.
Dowling, Ann P., Mahmoudi, Yasser
openaire +3 more sources
A lumped kinetic model for heavy fuel oil combustion
The study proposes a new procedure based on the Coats-Redfern method to develop kinetic model for predicting the combustion characteristics of heavy fuel oils.
Han, Yunqing +3 more
core
REVIEW ON PROCESSING COAL FLY ASH: CURRENT ADVANCES AND FUTURE PERSPECTIVES
This review aims to analyze the processing techniques employed for coal fly ash (CFA) and their implications. The study addresses the research problem of enhancing CFA utilization while minimizing environmental impacts.
K. Kamunur +3 more
doaj +1 more source
Combustion of methanol in diesel engine using diethyl ether as ignition enhancer
In this study, combustion of methanol in diesel engine is investigated using diethyl ether (DEE) as an ignition enhancer. Both experimental and numerical studies were performed and the results are compared with baseline diesel fuel.
Vallinayagam, R. +5 more
core
Detailed analysis of iso-Pentanol combustion chemistry in flames
In this study, two flames of iso-pentanol were stabilized on a 60-mm flat flame burner at a low pressure of 15 Torr and analyzed by a flame-sampling molecular-beam setup coupled to a mass spectrometer (MBMS).
Warkentin, Julia +4 more
core
Mechanochemical Activation as a Key Step for Enhanced Ammonia Leaching of Spent LiCoO2 Cathodes
The growing demand for lithium-ion batteries (LIBs) has led to an urgent need for sustainable recycling strategies for spent cathode materials. In this study, a mechanochemical approach was developed for the recovery of lithium and cobalt from end-of ...
Lyazzat Mussapyrova +5 more
doaj +1 more source
An experimental study on heavy fuel oil droplet combustion
This experimental work was carried out to understand the fundamental combustion characteristics of a single Heavy Fuel Oil (HFO) droplet in a thermal environment.
Roberts, William L. +5 more
core

