Results 21 to 30 of about 147,947 (209)
On the Riemann Problem for a Combustion Model [PDF]
SIAM Journal on Mathematical Analysis, 1993 Summary: This paper studies the Riemann problem for a combustion model and proves that the solution exists globally and the solution converges uniformly, away from the shock, to a travelling wave solution as \(t\to +\infty\). The results are obtained by using the method of characteristics, a maximum principle and that of the equation is a nonlinear ...
openaire +1 more source
Accounting for convective effects in zero-Mach-number thermoacoustic models [PDF]
, 2014 This paper presents a methodology to account for some mean-flow effects on thermo-acoustic instabilities when using the zero-Mach-number assumption. It is shown that when a computational domain is represented under the M=0 assumption, a nonzero-Mach ...
Bloxsidge +48 more
core +5 more sources
Energy Conversion and Management: X, 2022 A systematic compilation and evaluation of turbulent spray flame combustion data acquired from lab-scale spray-burners and CFD models validated with these are presented.
A.V. Brito Lopes, N. Emekwuru, K. Joshi
doaj +1 more source
A control orientated combustion model.
IFAC Proceedings Volumes, 2012 Abstract The control of Internal Combustion (IC) engines is dominated by conventional controllers that regulate the engine operating condition to set-points, which are usually derived from steady-state testing. A significant issue is that IC engines can spend much of their time operating under transient conditions, which take the engine away from ...
Fussey, P, Limebeer, D
openaire +1 more source
Enabling e-Research in combustion research community [PDF]
, 2006 This paper proposes an application of the Collaborative e-Science Architecture (CeSA) to enable e-Research in combustion research community. A major problem of the community is that data required for constructing modelling might already exist but ...
Dew, P.M. +3 more
core +1 more source
Measurement and Modeling of the Acoustic Response in a High Pressure Combustor [PDF]
, 2011 In this paper, a one dimensional acoustic network model is presented which can be used as a design tool to predict the limit cycle pressure oscillations in a gas turbine combustor. Analytically represented models are combined with measured flame transfer
Alemela, P.R. +4 more
core +7 more sources
A global model for the combustion of gas mixtures released from forest fuels [PDF]
, 2008 International ...
Garo, Jean-Pierre +4 more
core +3 more sources
Techno-economic analysis of chemical looping combustion with humid air turbine power cycle [PDF]
, 2014 Power generation from fossil fuel-fired power plant is the largest single source of CO₂ emission. CO₂ emission contributes to climate change. On the other hand, renewable energy is hindered by complex constraints in dealing with large scale application ...
Brandvoll +6 more
core +2 more sources
Internal Combustion Engine Modeling Framework in Simulink: Combustion Modeling
Evolutions in Mechanical Engineering, 2022 An internal combustion engine modeling framework has been developed in the MATLAB/Simulink environment to allow engine component blocks to be connected in a physically representative manner to reduce the model build time. Each component block, derived from physical laws, interacts with other blocks according to block connection.
openaire +1 more source
Influence of Eddy-Generation Mechanism on the Characteristic of On-Source Fire Whirl
Applied Sciences, 2019 This paper numerically examines the characterisation of fire whirl formulated under various entrainment conditions in an enclosed configuration. The numerical framework, integrating large eddy simulation and detailed chemistry, is constructed to assess ...
Cheng Wang +8 more
doaj +1 more source