Results 241 to 250 of about 8,259,326 (294)
Some of the next articles are maybe not open access.
Combustion Tests of a Staged Supersonic Combustor with a Strut
Journal of Propulsion and Power, 1998To avoid combustor ‐inlet interaction,a staged supersoniccombustorwitha strutforthee rst-stageinjection and second-stage wall injectors at its divergent section was introduced to increase the pressure in the divergent section under the limitation of the peak pressure at its minimum cross-sectional area section.
Sadatake Tomioka +3 more
openaire +1 more source
Combustion Tests of Reed Pellets
2015Proceedings of the 23rd European Biomass Conference and Exhibition, 1-4 June 2015, Vienna, Austria, pp.
Link, S., Kask, U., Krail, J., Plank, H.
openaire +1 more source
Journal of ASTM International, 2006
Abstract Two different test apparatuses are used at BAM to evaluate the safety of oxygen components: First, the “promoted ignition combustion test” according to ASTM G 124 [1] and to EIGA IGC Doc 13/02/E [2], and second, the new “metallic disk ignition test” that has not been standardized yet. The standard test method ASTM G 124 allows a
C Binder +5 more
openaire +1 more source
Abstract Two different test apparatuses are used at BAM to evaluate the safety of oxygen components: First, the “promoted ignition combustion test” according to ASTM G 124 [1] and to EIGA IGC Doc 13/02/E [2], and second, the new “metallic disk ignition test” that has not been standardized yet. The standard test method ASTM G 124 allows a
C Binder +5 more
openaire +1 more source
2010
Section I: General Introduction, C.E. Baukal, Jr. Testing Safety, C.E. Baukal, Jr. Experimental Design, J. Colannino Fluid Flow, W.Bussman and J. Colannino Temperature, C.E. Baukal, Jr. Heat Flux, C.E. Baukal, Jr . Pollution Emissions, C.E. Baukal, Jr. Combustion Noise, M.M. Fleifil, C.-C. Hantschk, and Edwin Schorer Flame Impingement Measurements, C.E.
openaire +1 more source
Section I: General Introduction, C.E. Baukal, Jr. Testing Safety, C.E. Baukal, Jr. Experimental Design, J. Colannino Fluid Flow, W.Bussman and J. Colannino Temperature, C.E. Baukal, Jr. Heat Flux, C.E. Baukal, Jr . Pollution Emissions, C.E. Baukal, Jr. Combustion Noise, M.M. Fleifil, C.-C. Hantschk, and Edwin Schorer Flame Impingement Measurements, C.E.
openaire +1 more source
Pyrolysis oil combustion tests in an industrial boiler
PyNe: Pyrolysis Network, 2000Combustion properties of various pyrolysis oils were studied at Oilon (Lahti, Finland) in a test boiler on 4 MW output level. Burner settings and boiler dimensions as well as oil properties were tested. A special emphasis was on oil specifications for boiler application.
Oasmaa Anja, Sipilä Kai, Kytö Matti
openaire +2 more sources
Fuel combustion test in constant volume combustion chamber with built-in adaptor
Science China Technological Sciences, 2010Combustion tests of pre-mixture of methane and air in constant volume combustion chamber (CVCC) have been carried out by means of flame propagation photo and gas pressure measurement, the effects of CVCC body temperature, intake pressure of pre-mixture of methane and air, equivalence ratio and location of the built-in adaptor have been investigated ...
HongGuang Zhang +5 more
openaire +1 more source
Combustion Conditions and Exposure Conditions for Combustion Product Toxicity Testing
Journal of Fire Sciences, 1984A number of procedures have been described in the literature for investigation of the inhalation toxicity of combustion products. There is need for agreement on test methods and test conditions to facilitate communication, allow the ex change of data, and provide a basis for control of hazards due to combustion products in fires. Combustion systems and
openaire +1 more source
High-Pressure Combustion Tube Tests
SPE Enhanced Oil Recovery Symposium, 1986ABSTRACT High pressure air fireflooding may have some benefits hitherto not observed at lower pressures. Combustion tube tests were conducted at pressures approaching 3,000 psi. Special start-up procedures were used, especially for the wet burns, to make the testing representative and also minimize the transient effects.
R. S. Prasad, J. A. Slater
openaire +1 more source
Particle monitoring in combustion tests
2011particulate ...
Patrizia Minutolo, Mario Commodo
openaire +3 more sources
Catalyst Preparation and Testing for Catalytic Combustion of Chloromethanes
2002The catalytic combustion of methylenechloride, carbontetrachloride, and chloroform, three of the chloromethanes, was investigated on metal oxide catalysts prepared on the monolith support or on the spherical alumina pellets. The prepared catalysts were tested for methylenechloride and carbontetrachloride at the different temperatures and at varying ...
Atalay, S, Alpay, HE, Atalay, FS
openaire +2 more sources

