Results 211 to 220 of about 312,278 (242)
Some of the next articles are maybe not open access.
IEEE Transactions on Power Electronics, 2020
Due to the continuous switching action of the inverter in the motor drive system, an electromagnetic interference (EMI) is generated in the system. Active EMI filter has a smaller volume and higher power density compared with the widely used passive EMI filter.
Yechi Zhang, Qiao Li, Dong Jiang
openaire +1 more source
Due to the continuous switching action of the inverter in the motor drive system, an electromagnetic interference (EMI) is generated in the system. Active EMI filter has a smaller volume and higher power density compared with the widely used passive EMI filter.
Yechi Zhang, Qiao Li, Dong Jiang
openaire +1 more source
2020 International Symposium on Electromagnetic Compatibility - EMC EUROPE, 2020
In this paper, reduction effect of a common-mode filter is discussed. When the performance of a common-mode filter is evaluated, it is necessary to consider not only S CC21 but also S CD21 . Using these two parameters, the common-mode current flowing on the secondary side of the common-mode filter was formulated.
Tohlu Matsushima +4 more
openaire +1 more source
In this paper, reduction effect of a common-mode filter is discussed. When the performance of a common-mode filter is evaluated, it is necessary to consider not only S CC21 but also S CD21 . Using these two parameters, the common-mode current flowing on the secondary side of the common-mode filter was formulated.
Tohlu Matsushima +4 more
openaire +1 more source
IEEE Transactions on Microwave Theory and Techniques, 2014
A new common-mode bandstop filter (CM-BSF) with an all-pass performance (from dc to 9 GHz) for differential signals is proposed by using a C-shaped patterned ground structure (PGS) with meandered signal lines on a two-layer printed circuit board (PCB).
Tsui-Wei Weng +4 more
openaire +1 more source
A new common-mode bandstop filter (CM-BSF) with an all-pass performance (from dc to 9 GHz) for differential signals is proposed by using a C-shaped patterned ground structure (PGS) with meandered signal lines on a two-layer printed circuit board (PCB).
Tsui-Wei Weng +4 more
openaire +1 more source
2017 IEEE International Symposium on Circuits and Systems (ISCAS), 2017
This paper presents a CM noise suppression technique from self-calibration of a 20-Gb/s source-series terminated (SST) driver using an on-chip process monitoring circuit designed and simulated in a 65-nm CMOS process. An unbalanced charging and discharging loop results in an asymmetric rise and fall time of the output signal and is an intrinsic source ...
Khawaja Qasim Maqbool +5 more
openaire +1 more source
This paper presents a CM noise suppression technique from self-calibration of a 20-Gb/s source-series terminated (SST) driver using an on-chip process monitoring circuit designed and simulated in a 65-nm CMOS process. An unbalanced charging and discharging loop results in an asymmetric rise and fall time of the output signal and is an intrinsic source ...
Khawaja Qasim Maqbool +5 more
openaire +1 more source
2000 26th Annual Conference of the IEEE Industrial Electronics Society. IECON 2000. 2000 IEEE International Conference on Industrial Electronics, Control and Instrumentation. 21st Century Technologies and Industrial Opportunities (Cat. No.00CH37141), 2002
Predicting and solving EMI emissions related to common mode (CM) ones in pulse with modulation (PWM) inverter induction motor drive systems requires various frequency-dependent effects to be considered. Thus, the application of active circuitry to increase the performance per size and prevent dependency on some parameters of the motor for ...
K. Gulez +3 more
openaire +1 more source
Predicting and solving EMI emissions related to common mode (CM) ones in pulse with modulation (PWM) inverter induction motor drive systems requires various frequency-dependent effects to be considered. Thus, the application of active circuitry to increase the performance per size and prevent dependency on some parameters of the motor for ...
K. Gulez +3 more
openaire +1 more source
2017 IEEE Electric Ship Technologies Symposium (ESTS), 2017
Objectives of modeling conducted EMI — Analytically predict parasitic behavior of power electronic systems — Understand sources of leakage currents Identify dominating parasitics Inform/guide measurements to support modeling and analysis Predict the impact of new technologies (e.g., WBG devices) Evaluate methods to mitigate CM current-Control ...
Aaron D. Brovont, Steven D. Pekarek
openaire +1 more source
Objectives of modeling conducted EMI — Analytically predict parasitic behavior of power electronic systems — Understand sources of leakage currents Identify dominating parasitics Inform/guide measurements to support modeling and analysis Predict the impact of new technologies (e.g., WBG devices) Evaluate methods to mitigate CM current-Control ...
Aaron D. Brovont, Steven D. Pekarek
openaire +1 more source
2015
As mentioned in the introduction of this book, humans demonstrate versatile and stable interactions with uncertain environments. Such stability is guaranteed by generating efficient and task-related restoring forces in response to environmental displacements [51], and is accomplished by co-activation of the muscles acting on the joints.
openaire +1 more source
As mentioned in the introduction of this book, humans demonstrate versatile and stable interactions with uncertain environments. Such stability is guaranteed by generating efficient and task-related restoring forces in response to environmental displacements [51], and is accomplished by co-activation of the muscles acting on the joints.
openaire +1 more source
Design of broadband MIMO antenna based on common and differential mode (CM/DM) method
2021 IEEE International Workshop on Electromagnetics: Applications and Student Innovation Competition (iWEM), 2021Zhe Peng +3 more
openaire +1 more source
Common Mode Noise Sources Analysis and Volume Optimized CM-EMI Filter Design for a TM-PFC
2022 12th Smart Grid Conference (SGC), 2022Kamran Moradi Golmakani +2 more
openaire +1 more source
2022 IEEE International Symposium on Electromagnetic Compatibility & Signal/Power Integrity (EMCSI), 2022
Nobuo Kuwabara +2 more
openaire +1 more source
Nobuo Kuwabara +2 more
openaire +1 more source