Results 181 to 190 of about 14,286 (292)

Lightweight and High-Strength Carbon Bulk Preparation Via Low-Temperature Pressureless Sintering of Sugar-Derived Carbon. [PDF]

open access: yesAdv Sci (Weinh)
Hou C   +10 more
europepmc   +1 more source

Technobiological Pathways for High‐CO₂ Capture Using Micro‐/Macroalgae: Genetic Engineering, Process Automation, and Value‐Added Bioproducts

open access: yesAsia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Greenhouse gas (GHG) emissions have emerged as one of the most critical drivers of climate change; this is primarily due to high concentrations and long atmospheric life of carbon dioxide (CO2). For a significant amount of time, various biological processes such as microalgal cultivation, cyanobacterial systems, photosynthetic microorganisms ...
Sadhana Semwal, Harish Chandra Joshi
wiley   +1 more source

Sustainable Graphene Oxide–Intercalated Bentonite Composite for the Effective Removal of Imidacloprid From Water: Adsorption Performance, Isotherm, and Kinetics

open access: yesAsia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Water is a fundamental necessity for our existence, but its rapid contamination is causing devastating effects on the environment and health of living species worldwide. Adsorptive removal of pollutants is one of the popular water treatment techniques because of its simplicity, affordability, and the broad range of available adsorbents.
Priyanka Negi   +3 more
wiley   +1 more source

Anodic dissolution mechanisms of iron in bentonite slurries. [PDF]

open access: yesNpj Mater Degrad
Kulkarni PV   +3 more
europepmc   +1 more source

Eco‐Friendly Aqueous Polymeric Binders for High‐Performance Graphite Anodes: Structure–Property Insights for Lithium‐Ion Batteries

open access: yesAsia-Pacific Journal of Chemical Engineering, EarlyView.
ABSTRACT Polyvinylidene fluoride (PVdF) is commonly used as a binder material in the preparation of anode or cathode electrode slurries for commercial Li‐ion batteries (LIBs). High‐cost PVdF binder generally requires the use of toxic and environmentally unfriendly N‐methyl‐2‐pyrrolidone (NMP) as a solvent for dissolution.
Bayram Devlet   +4 more
wiley   +1 more source

Studies of Thermal Conductivity of Graphite Foil-Based Composite Materials. [PDF]

open access: yesMaterials (Basel)
Shulyak VA   +8 more
europepmc   +1 more source

Gleaning the Rocky Shore? 2500 Years of Coastal Resource Use at Red Bluff 1, GunaiKurnai Country, SE Australia

open access: yesArchaeology in Oceania, EarlyView.
ABSTRACT Shell middens in Gippsland along the eastern half of Victoria's coastline have usually been characterised as small, short‐duration camp sites with relatively low shell densities and low taxonomic diversity. Here we present new excavation results from a dense, high‐diversity site at Red Bluff near the eastern end of GunaiKurnai Country, a ...
Patrick Faulkner   +17 more
wiley   +1 more source

Experimental investigation on mechanical properties of iron metal matrix reinforced with MAX phase V2AlC-GO. [PDF]

open access: yesSci Rep
Alemu EM   +10 more
europepmc   +1 more source

Scaling of Planar Sodium‐Nickel Chloride Battery Cells to 90 cm2 Active Area

open access: yesBatteries &Supercaps, Volume 8, Issue 3, March 2025.
Large planar Na β′′ alumina electrolytes are prepared by tape‐casting and die‐pressing. These ceramic electrolytes are used to prepare planar sodium‐nickel chloride cells with 90 cm2 active area, providing a high capacity of 7 Ah. Successful cell cycling is demonstrated at 300 °C at rates up to C/4 (20 mA cm−2) for a cumulative capacity of 3.6 Ah cm−2.
T. Lan   +10 more
wiley   +1 more source

Home - About - Disclaimer - Privacy