Results 41 to 50 of about 9,064,022 (287)
Levelized cost of energy and storage of compressed air energy storage with wind and solar plants in
Journal of Thermal EngineeringTo reduce greenhouse gas emissions and the environmental impact of fossil fuels, Morocco has decided to increase the use of renewable energy resources. The intermittent nature of renewable energy resources causes instability in the power grid.
Youness MASAAF
doaj +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Overview of current development in electrical energy storage technologies and the application potential in power system operation [PDF]
, 2015 Electrical power generation is changing dramatically across the world because of the need to reduce greenhouse gas emissions and to introduce mixed energy sources.
Clarke, Jonathan +3 more
core +1 more source
Current Status and Challenges in Data Collection for Aerospace Coatings Deposited by Plasma Spraying
Advanced Engineering Materials, EarlyView.An innovative approach has been integrated into the GRENAT project to optimize plasma spraying and coating performance. Raw materials are accelerated and melted in the plasma generated by torches, creating coatings. Monitoring sensors collect process data which are combined with ex situ characterization data.
Lila Randriamananjara +8 more
wiley +1 more source
Compressed Air Energy Storage Installation for Renewable Energy Generation [PDF]
E3S Web of Conferences, 2019 Compressed Air Energy Storage (CAES) installations are used for storing electrical power, under the form of potential energy from compressed air. The heat generated during compression can be stored to improve the efficiency of compression-expansion cycle.
Borzea Claudia +7 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
, 2013 Electrical Energy Storage (EES) refers to a process of converting electrical energy from a power network into a form that can be stored for converting back to electrical energy when needed [1-3]. Such a process enables electricity to be produced at times of either low demand, low generation cost or from intermittent energy sources and to be used at ...
Haisheng Chen +3 more
openaire +2 more sources
Additive Manufacturing of Alumina‐Reinforced Elastomers
Advanced Engineering Materials, EarlyView.Vat‐photopolymerized elastomers reinforced with platelet‐shaped alumina exhibited preferential orientation, reduced porosity, and significantly enhanced mechanical performance. A 3 wt% platelet loading increased tensile strength from 12.4 to 45.7 MPa, highlighting the critical role of filler morphology in elastomeric VPP composites.
Majid Barzegar Keyvani +6 more
wiley +1 more source
发电技术ObjectivesCompressed air energy storage is a type of energy storage technology with large capacity, long cycle, low cost and high efficiency. Due to the strict requirements of gas storage chambers, gaseous compressed air energy storage cannot be widely ...
JI Haimin +9 more
doaj +1 more source
Energy Reports, 2021 Energy storage systems critically assist in the implementation of renewable energy sources. However, greenhouse gas emissions associated with the energy storage methods have received insufficient attention, especially for arid climate implementation ...
Manal AlShafi, Yusuf Bicer
doaj +1 more source