Results 71 to 80 of about 206,585 (306)

Harnessing Fungal Biowelding for Constructing Mycelium‐Engineered Materials

Advanced Engineering Materials, EarlyView.
Mycelium‐bound composites (MBCs) offer low‐carbon alternatives for construction, yet interfacial bonding remains a critical challenge. This review examines fungal biowelding as a biocompatible adhesive, elucidating mycelium‐mediated interfacial mechanisms and their role in material assembly. Strategies to optimize biowelding are discussed, highlighting
Xue Brenda Bai, Xinrui Sarah Niu, Zhao Qin   +2 more
wiley   +1 more source

Inelastic Model for Cyclic Biaxial Loading of Reinforced Concrete [PDF]

, 1974
National Science Foundation Research Grant GI ...
Darwin, D., Pecknold, D.A.W.
core  

On the Lightweight Potential of Laser Additive Manufactured NiTi Triply Periodic Minimal Sheet Lattices

Advanced Engineering Materials, EarlyView.
This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo, Shuo Qu, Shiming Gao, Xu Song   +3 more
wiley   +1 more source

Effect of Loading Direction on Tensile-Compressive Mechanical Behaviors of Mg-5Zn-2Gd-0.2Zr Alloy with Heterogeneous Grains

Crystals
The tension-compression yield asymmetry caused by the strengthening of Mg-Zn-Gd-Zr alloy due to extrusion deformation is an important issue that must be addressed in its application.
Jieming Chen, Lei Xiao, Xuefang Wang, Zhuo Li, Chen Wang, Bingshu Wang, Junfeng Chen, Pan Liu, Xinyao Zhang   +8 more
doaj   +1 more source

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

Advanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin, Samson Dare Oguntuyi, Peter Apata Olubambi   +2 more
wiley   +1 more source

Experimental assessment of the influence of multiple cyclic loading on the dynamic modulus of elasticity of concrete

MATEC Web of Conferences, 2017
The goal of the experiment was to determine the influence that cyclic loading has on concrete dynamic modulus of elasticity and compressive strength. Each test specimen was subjected to cyclic loading with the loading force equivalent to one third of the
Misák Petr, Kocáb Dalibor, Daněk Petr, Kucharczyková Barbara, Topolář Libor   +4 more
doaj   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

Axial compressive behavior of circular RC stub columns jacketed by UHPC and UHPFRC

Case Studies in Construction Materials
This study investigated the axial compressive behavior of circular reinforced concrete (RC) stub columns jacketed by ultra-high performance concrete (UHPC) and ultra-high performance fiber reinforced concrete (UHPFRC).
Hoang An Le, Vinh Ha Ho, Phu-Cuong Nguyen, Trung Phong Le, My Ngoc-Tra Lam   +4 more
doaj   +1 more source

An Experimental Study Examining the Size Effect on the Compressive Dynamic Performance of Nuclear Power Containment Concrete

Advances in Materials Science and Engineering, 2020
To study the size effect of nuclear power containment concrete (NPCC) under compressive dynamic performance, the cube concrete specimens with 3 different cube sizes were measured at 10 different loading strain rates using a hydraulic servo, and the ...
Furong Li, Guoxing Chen, Hui Long
doaj   +1 more source

Supported ITZ modification efficiencies via surface coating nanoparticles on aggregate and its influence on properties [PDF]

, 2019
In order to modify the porous interfacial transition zone (ITZ) microstructure of concrete more efficiently, a method of coating aggregate surfaces by using several nanoparticles was evaluated in this study. The compressive strength, chloride penetration
De Schutter, Geert, Han, Hao, Wu, Kai, Xu, Linglin, Yang, Xiaojie   +4 more
core   +1 more source