Results 51 to 60 of about 97,848 (165)
The Compressibilities of the Elements and their Relations to Other Properties [PDF]
Proceedings of the National Academy of Sciences, 1915 n ...
openaire +2 more sources
Effect of annealing temperature on the structure and properties of FeCoCrNiMo high-entropy alloy
High Temperature Materials and Processes, 2022 FeCoCrNiMo high-entropy alloy was melted by vacuum arc melting. The alloys were vacuum annealed at 873, 1,073, and 1,273 K, respectively. X-ray diffractometer (XRD), scanning electron microscope (SEM), simultaneous thermal analyzer, microhardness tester,
Sheng Lei +5 more
doaj +1 more source
MetalsBased on molecular dynamics simulation, this work investigated the influences of temperature and Ti volume fractions on the compressive deformation of Ti/Al layered composites.
Shuqin Chen +5 more
doaj +1 more source
CONTRACTILE PROPERTIES OF COMPRESSED MONOLAYERS OF ACTOMYOSIN [PDF]
Journal of General Physiology, 1952 1. Surface-spread actomyosin, compressed into fibers, shows biological properties of contractility and enzymic activity. 2. In unloaded contractions, wet and dry weight determinations show no appreciable water loss in contraction. The fibers also evince a strong ATP-ase activity. 3. A structural continuity in the fibers by
openaire +2 more sources
The Al Effects of Co-Free and V-Containing High-Entropy Alloys
Metals, 2017 In this study, five-component high-entropy alloys (HEAs) AlxCrFeNiV (where x denotes the molar ratio, x = 0, 0.1, 0.3, 0.5, 0.75, 1, and 1.5) were prepared using an arc-melting furnace. The effects of the addition of the Al on the crystal structures were
Songqin Xia +4 more
doaj +1 more source
Science and Engineering of Composite Materials, 2015 The Cu-7vol.%ZrB2 alloy examined in this study was consolidated via powder metallurgy (PM) processing by combining mechanical alloying and hot pressing. Powder mixture with composition: 94.78 wt.% copper, 4.1 wt.% zirconium, and 1.12 wt.% boron was used ...
Ružić Jovana +4 more
doaj +1 more source
Entropy, 2018 The microstructure, Vickers hardness, and compressive properties of novel low-activation VCrFeTaxWx (x = 0.1, 0.2, 0.3, 0.4, and 1) high-entropy alloys (HEAs) were studied. The alloys were fabricated by vacuum-arc melting and the characteristics of these
Weiran Zhang, Peter K. Liaw, Yong Zhang
doaj +1 more source
Mechanical Properties of Compressed Wood in Accordance with the Compression Ratio
Mokuzai Gakkaishi, 2010 本研究では圧縮木材を構造用接合具として使用することを意図し，様々な圧縮率のスギの圧縮木材を用いて，各種力学特性値の密度との関係を調べた。非圧縮材料の物性値を元にした基準化を行うことで，材質向上の傾向を明らかにするとともに，圧密の過程に伴う細胞の変形モデルと比較することで，定性的な説明を行った。結果，縦圧縮・引張および曲げ特性値は密度に比例したが，せん断特性はLR面とLT面でそれぞれ異なった。LT面横圧縮特性は弾性率，強度ともに密度上昇率に対し約2乗に比例して増大した一方，LR方向のそれは早材細胞が完全に圧密細胞に変わる圧縮率程度まではあまり変化無く，それ以降に急激に上昇する結果が得られた。これらの傾向をハニカムセルの変形を考慮する事でモデル化し，元材料の力学特性値と圧縮率 ...
Kitamori, Akihisa +3 more
openaire +1 more source
BuildingsSeawater sea sand-engineered cementitious composites (SS-ECCs) provide a potential solution to the shortage of freshwater and sand resources for coastal and offshore construction. However, systematic studies on the combined effects of fiber parameters in
Zheming Wen +4 more
doaj +1 more source
Effect of Cell Number and Arrangement on the Compressive Behavior of Cellular Structures
Applied MechanicsThe mechanical response of cellular structures is governed not only by relative density and average cell geometry but also by the spatial arrangement of cells.
Kohei Tateyama +2 more
doaj +1 more source