Corrosion fatigue of low carbon steel under compressive residual stress field [PDF]
Procedia Engineering, 2018 This paper presents experimental investigation and numerical modeling of the effect of compressive residual stress on the corrosion fatigue life of a low carbon steel.
Comlekci, Tugrul +5 more
core +3 more sources
Residual stress field of HIPed silicon nitride rolling elements [PDF]
, 2002 The residual stress field of HIPed Si3N4 rolling elements were studied. Two kinds of HIPed Si3N4 ball blanks self-finished at different nominal lapping loads ranging from 1.3 to 10.87 kgf/ball and four kinds of commercially finished 1/2 in (12.7 mm ...
Hadfield, M, Kang, J, Tobe, S
core +1 more source
Passivity of Spring Steels with Compressive Residual Stress [PDF]
Metals, 2018 The electrochemical corrosion behavior and the semiconducting properties of the passive film formed on a coil spring steel were investigated in a buffer solution at pH 9. The anodic dissolution was mitigated, and the passive film grew faster for the spring steel with compressive residual stress than the one without stress.
Kyu-Hyuk Lee +3 more
openaire +2 more sources
Compressive residual stress in X-ray fractography.
Journal of the Society of Materials Science, Japan, 1987 X-ray fractography is a technique for analysing the cause and mechanism of fracture from the information obtained by X-ray irradiation on the fractured surface. It has been shown that a good correlation exists between the residual stress on the half value breadth of diffraction profile and the stress intensity factor that had caused the fracture. X-ray
Shotaro KODAMA +2 more
openaire +2 more sources
The effect of material cyclic deformation properties on residual stress generation by laser shock processing [PDF]
, 2019 Laser shock processing (LSP) is a mechanical surface treatment to induce a compressive residual stress state into the near surface region of a metallic component.
Angulo, I. +6 more
core +1 more source
Effect of high-pressure rolling followed by laser processing on mechanical properties, microstructure and residual stress distribution in multi-pass welds of 304L stainless steel [PDF]
, 2016 Multi-pass fusion welding by a filler material (wire) is normally carried out to join thick steel sections used in most engineering applications. Multiple thermal cycles from a multi-pass weld resulted in a variable distribution of residual stress field ...
Ganguly, Supriyo +3 more
core +2 more sources
Cold Compression Residual Stress Reduction in Aluminium Alloy 7010
Materials Science Forum, 2000 peer ...
David A. Tanner +2 more
openaire +2 more sources
Application of multireflection grazing incidence method for stress measurements in polished Al–Mg alloy and CrN coating [PDF]
, 2012 Multi-reflection grazing incidence geometry, referred to as MGIXD, characterized by a small and constant incidence angle, was applied to measure low surface stresses in very thin layers of Al–Mg alloy and CrN coating.
BACZMANSKI, Andrzej +9 more
core +6 more sources
Fatigue performance of thermal spray coatings on carbon steel: a review [PDF]
, 2019 This paper contributes to a review of the research of the fatigue behaviour of thermal spray coatings on carbon steel. Previous studies provide the experimental characterization of the fatigue resistance of coated carbon steel.
Harimon, M. A. +3 more
core +1 more source
Effects of compressive stress on localized corrosion in AA2024-T3 [PDF]
, 2006 The effect of compressive stress on intergranular corrosion (IGC) of AA2024-T3 was studied using a constant load and simultaneous electrochemical measurement.
Frankel, G. S., Liu, Xiaodong
core +2 more sources