Results 101 to 110 of about 362,988 (397)
Case Studies in Thermal EngineeringTo the users, low-temperature adiabatic compressed air energy storage is a promising technology for energy storage. In this work, the parameter selection method of a 200 kW scale CAES system are studied.
Fengyu Li, Yueping Yu
doaj +1 more source
Experimental on-stream elimination of resonant whirl in a large centrifugal compressor [PDF]
Resonant whirl condition during operation of a multi-stage centrifugal compressor at higher than anticipated speeds and loads was reported. The condition was diagnosed by a large scale computerized Machinery Condition Monitoring System (MACMOS).
Bhat, G. I., Eierman, R. G.
core +1 more source
A preliminary assessment of the initial compression power requirement in CO2 pipeline “Carbon Capture and Storage (CCS) technologies" [PDF]
, 2016 CO2 captured from fossil-fueled power generation plants is said to be economically transported via pipelines over long distances. The CO2 must be compressed to pipeline specifications using compressors and pumps that are driven by gas turbine (GT) or ...
Anosike, Nnamdi Benedict +2 more
core +3 more sources
Advanced Engineering Materials, EarlyView.Plasma‐assisted hybrid friction stir welding of dissimilar AlCu joints employs localized plasma preheating to balance heat input and enhance plastic flow. The optimized process reduces axial force by up to 35%, refines the microstructure, and achieves ≈96% joint efficiency.
Deepak Kumar Yaduwanshi +3 more
wiley +1 more source
Preliminary Design and System Considerations for an Active Hybrid Laminar Flow Control System
Aerospace, 2019 Hybrid laminar flow control or HLFC design is a complex and multi-disciplinary process, which demands a thorough understanding of all aspects from a global systems viewpoint.
G. Kalarikovilagam Srinivasan +1 more
doaj +1 more source
Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6
Advanced Engineering Materials, EarlyView.The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter +4 more
wiley +1 more source
IEEE AccessThis paper proposes a pyriform stator tooth body shape of axial flux permanent magnet motors (AFPMMs) based on soft magnetic composite (SMC) to enhance torque density.
Lijian Wu +5 more
doaj +1 more source
Centrifugal-reciprocating compressor [PDF]
, 1984 A centrifugal compressor is described which includes at least one pair of cylinders arranged in coaxial alignment and supported for angular displacement about a common axis of rotation normally disecting a common longitudinal axis of symmetry for the ...
Higa, W. H.
core +1 more source
Can Ti‐Based MXenes Serve as Solid Lubricants for Brake Applications? A Tribological Study
Advanced Engineering Materials, EarlyView.This study explores the first implementation of Ti‐based MXenes materials in brake pad friction composite material. The resulting composite material exhibits a 48% reduction in the wear rate; alongside significant improvements are observed for thermal and mechanical properties.
Eslam Mahmoud +7 more
wiley +1 more source
LubricantsTo address the lack of reliable measurement methods for identifying wear mechanisms and predicting the state of mechanical seal tribo-parts, this study proposes a method for characterizing tribological behavior based on measuring face vibration ...
Yunfeng Song +4 more
doaj +1 more source