Results 141 to 150 of about 64,360 (309)
Advanced Engineering Materials, EarlyView.This plot compares experimental tensile stress–strain curves (with 4 different strain rates) and corresponding modelled curves (obtained using the optimised sets of Voce and Miller–Norton parameter values shown). The inferred M‐N values, characterizing the creep, are very similar to those obtained via conventional creep testing.
S. Ooi, R. P. Thompson, T. W. Clyne
wiley +1 more source
, 2012 On the basis of the classic ARI compressor model, the mass flow-rate and input power were corrected with the level of suction gas superheat, especially the superheat degrees below zero. refrigerant dissolved in the oil pool, at the discharge pressure and
Tao, Hong +3 more
core
Advanced Engineering Materials, EarlyView.Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source
, 2012 Thermodynamic models to simulate positive displacement compressors are well known for a few decades already and can describe the compressor performance quite well.
Ignatiev, Kirill Michailovich
core
In Situ Micromechanical Study of Bimodal γ′–γ″ Precipitate Assemblies in Ni–Cr–Al–Nb Superalloy
Advanced Engineering Materials, EarlyView.A Ni–Cr–Al–Nb superalloy with a bimodal γ′–γ″ precipitate distribution is developed. Composite precipitate assemblies form through heterogeneous nucleation, effectively impeding dislocation motion. Micropillar compression reveals high strength at room and elevated temperatures, governed by precipitate shearing, with coupled faulting mechanisms ...
Ujjval Bansal +4 more
wiley +1 more source
CFD analysis of two-dimensional linear compressor cascade flows
, 2011 This project analyzes two-dimensional linear cascade flows of an axial compressor on the stator vanes. It analyzes the influence of the angle of attack in the leading edge for different pressure ratios.
García Unzue, Javier
core
Advanced Engineering Materials, EarlyView.Knowledge‐based atomistic workflows are presented for mechanical and thermodynamic properties. By coupling modular simulations with ontology‐aligned metadata and provenance, Fe case studies on elastic behavior, defects, thermal properties, and Hall–Petch strengthening reveal how FAIR, queryable, and reusable simulation data can be generated. Mechanical
Abril Azócar Guzmán +5 more
wiley +1 more source
R32 Compressor for Air conditioning and Refrigeration applications in China
, 2012 This paper evaluates the compressor performance and reliability impact by using R32 refrigerant for air conditioning (residential and commercial system); Performance and reliability impacts are compared with different popular refrigerants used in China ...
Zhan, Honghong +3 more
core
Advanced Engineering Materials, EarlyView.Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar +7 more
wiley +1 more source
, 2012 A numerical analysis is performed to systematically calculate the performance, rotor temperature distributions, and rotor thermal deformation of an R134a screw compressor. The analysis procedure includes three major steps.
Hsieh, Wenhsin +3 more
core