Results 211 to 220 of about 8,052,715 (295)

Multispectral UV Imaging on Capacitive CMOS Arrays Enabled by Solution‐Processed Metal‐Oxide Nanoparticles

open access: yesAdvanced Science, EarlyView.
Ultraviolet (UV) imagers are important for a variety of applications but often require dedicated semiconductor process flows. Here, a versatile capacitive CMOS platform is transformed into a visible‐blind, multispectral UV imager through post‐CMOS functionalization with solution‐processed metal‐oxide nanoparticles. The UV‐induced photodielectric effect
Suman Kundu   +5 more
wiley   +1 more source

Engineering Slow‐Carrier Interfacial Recombination Enables Tailored Spectral Response

open access: yesAdvanced Science, EarlyView.
This work demonstrates that weak‐drift slow carriers are preferentially captured at generic semiconductor surfaces/interfaces and recombine. This process is manipulated to achieve tailored spectral response. A tens of µm‐wide depletion region is created to observe surface collection rates for photocarriers generated at different positions.
Yibo Zhang   +5 more
wiley   +1 more source

Unsuccessful Coupling of Weakly Coordinating Anion–Based Mg Salts and Alkoxyalkylamine Solvents for Rechargeable Mg Battery Application: Trace Water‐Driven Interfacial Failure

open access: yesAdvanced Science, EarlyView.
Combining recently established two ground‐breaking concepts, the adoption of WCAs and the use of alkoxyalkylamine‐based solvents in electrolyte formulations for rechargeable magnesium metal batteries, has led to unexpectedly unsuccessful electrochemical Mg plating/stripping performance. Comprehensive experimental and computational analyses revealed the
Toshihiko Mandai   +4 more
wiley   +1 more source

Nanoparticle‐Mediated Bubble Suppression During Droplet Solidification for Mechanical Reinforcement

open access: yesAdvanced Science, EarlyView.
Nanoparticles mediate droplet solidification by raising nucleation temperature, refining dendrites, and slowing freezing‐front advance, thereby suppressing trapped air bubbles in droplet‐based 3D printing. This strategy reduces bubble volume fraction by ∼35% and increases compressive strength by up to 39%, offering a low‐cost route to stronger printed ...
Runmiao Gao   +10 more
wiley   +1 more source

Drop‐Location‐Insensitive Droplet‐Based Electricity Generator Using Polydimethylsiloxane Slippery Covalently Attached Liquid Coatings

open access: yesAdvanced Science, EarlyView.
Drop‐location sensitivity remains a key barrier to practical droplet‐based electricity generators (DEGs). Here, a polydimethylsiloxane slippery covalently attached liquid (PDMS‐SCAL)‐coated interface promotes droplet sliding instead of splitting or bouncing, allowing stable electricity generation from randomly falling raindrops. The resulting PDMS‐SCAL‐
Jung Bin Yang   +6 more
wiley   +1 more source

Home - About - Disclaimer - Privacy