Results 101 to 110 of about 4,118 (228)

Reliability analysis of shear strengthening EBR FRP models [PDF]

open access: yes, 2011
This work presents a statistically oriented study aiming to assess the reliability of some of the most well known design models available for the prediction of the contribution of fiber reinforced polymer (FRP) systems applied according to the ...
Barros, Joaquim A. O., Lima, João L. T.
core   +1 more source

The design and retrofit of buildings for resistance to blast-induced progressive collapse [PDF]

open access: yes, 2009
Thesis (M. Eng.)--Massachusetts Institute of Technology, Dept. of Civil and Environmental Engineering, 2009.Includes bibliographical references (leaf 44).In recent years, concern has risen drastically regarding the suitability of structural design for ...
Abbott Galvão Sobreira Lopes, Isabel
core  

Use of bolted steel plates for strengthening of reinforced concrete beams and columns [PDF]

open access: yes, 2011
Reinforced concrete (RC) structures often need strengthening due to defective construction, having higher loads than those foreseen in the initial design of the structure, or as a result of material deterioration or accidental damage.
Cheng, B   +4 more
core   +1 more source

Eccentrically-compressed reinforced concrete columns strengthened with partial jacketing

open access: yesRevista ALCONPAT, 2018
The behavior of six uniaxial compression columns is investigated. Specimen featured an initial section of (120 x 200) mm2, a final section of (200 x 200) mm2 and height of 1.600 mm, strengthened on the tensile and compression sides with plaster or not ...
Denio Ramam Carvalho de Oliveira   +2 more
doaj   +1 more source

Strengthening of Nurul Ilmi Mosque with Concrete Jacketing

open access: yesINSIST, 2017
Abstract—Nurul Ilmi moesque is one of building for worship located in University of Andalas. In 2008 the new building of mosques was designed using previous indonesian seismic code, SNI 1726: 2002. The right side of the new mosque was constructied in 2009.
Fauzan Fauzan   +4 more
openaire   +2 more sources

Experimental Investigation on Axial Strength Improvement of Cold-Formed Steel Jacketed Concrete Stub Columns

open access: yesInternational Journal of Concrete Structures and Materials
This paper presents an experimental study on the behavior of low-strength concrete columns confined with cold-formed steel under axial compression. The laboratory test specimens consist of four groups of rectangular concrete stub columns in the size of ...
Apisith Waenpracha   +2 more
doaj   +1 more source

Numerical analysis of strengthening concrete columns by high performance fibre concrete

open access: yesMATEC Web of Conferences, 2018
Concrete is a material that has advantages and disadvantages. High strength in pressure, as well as increased mechanical resistance are its advantages, on the other side, it has a lower tensile strength as its disadvantage.
Vavruš Martin   +2 more
doaj   +1 more source

Revitalizing Infrastructure: Assessing Concrete Jacketing for Reinforced Concrete Column Rehabilitation

open access: yesInternational Journal of Innovative Research in Computer Science and Technology
The rehabilitation of deteriorating civil engineering infrastructure, encompassing bridges, buildings, columns, beams, supporting beams, marine structures, and roads, presents a formidable challenge in contemporary engineering practice. As society's demand for upgraded infrastructure escalates, the imperative to address deteriorating structures becomes
openaire   +1 more source

Concrete-to-concrete bond strength. Influence of the roughness of the substrate surface [PDF]

open access: yes, 2004
An experimental study was performed to evaluate the bond strength between two concrete layers, for different techniques for increasing the roughness of the substrate surface.
Branco, Fernando A. B.   +2 more
core   +1 more source

Experimental analysis of reinforced concrete beams strengthened with steel bars and epoxy structural adhesive

open access: yesRevista ALCONPAT, 2018
This work was aimed at analyzing the efficiency of the strengthening of reinforced concrete beams with the addition of steel bars and epoxy adhesive. Five beams were produced, out of which four beams were strengthened to flexure.
Ricardo José Carvalho Silva   +4 more
doaj   +1 more source

Home - About - Disclaimer - Privacy