Results 21 to 30 of about 2,572,239 (182)
Communications, 2011 This paper deals with the numerical analysis of plastic deformation and damage development in S235JR steel in complex stress states. The material Gurson Tvergaard Needleman (GTN) model was applied. The analysis was performed for notched bars subjected to
Wiktor Wcislik
doaj +1 more source
Effect of Initial Porosity on Material Response Under Multi-Axial Stress State for S235JR Steel
Archives of Civil Engineering, 2012 The effect of the initial porosity on the material response under multi-axial stress state for S235JR steel using the Gurson-Tvergaard-Needleman (GTN) material model was examined.
Kossakowski P.G.
doaj +1 more source
The Experimental Assessment Of The Effect Of Paper Waste Ash And Silica Fume On Improvement Of Concrete Behavior [PDF]
مهندسی عمران شریف, 2021 The idea of using paper wastes in concrete to reduce environmental pollution and Silica fume to improve the properties of concrete is a huge transformation in the building industry.
J. Pourazar +4 more
doaj +1 more source
Fatigue Strength of an Over One Hundred Year Old Railway Bridge
The Baltic Journal of Road and Bridge Engineering, 2013 The paper analyzes the fatigue strength of steel sampled from a railway bridge with a service life of over hundred years. The fatigue strength of the material was used to analyze the structural capacity of this railway bridge with such life expectancy ...
Paweł Grzegorz Kossakowski
doaj +1 more source
Influence of Initial Porosity on Strength Properties of S235JR Steel at Low Stress Triaxiality
Archives of Civil Engineering, 2012 The paper discusses the influence of the initial parameters on the strength parameters of S235JR steel at low stress triaxiality. The analysis was performed using the Gurson-Tvergaard-Needleman (GTN) material model, which takes into consideration the ...
Kossakowski P.G.
doaj +1 more source
Strength Modeling of High Strength Concrete
IOSR Journal of Mechanical and Civil Engineering, 2014 Silica fume is being used all over the world for many years in the area where high strength and durable concrete were required, and it also improves the characteristicsof both fresh and hard concrete. Incorporation of the silica fume increases the mechanical properties of high strength concrete than the conventional concrete.
Zealakshmi D +2 more
openaire +1 more source
Transactions of the VŠB: Technical University of Ostrava, Civil Engineering Series, 2016 Experimental and numerical results of a chloride ingress study conducted on samples drilled from different locations of a reinforced concrete slab, previously loaded until failure, are presented.
Sosdean Corina +2 more
doaj +1 more source
Journal of Civil Engineering and Management, 2000 Experimental and theoretical investigations associated with reliability and durability problems of concrete structures of electric power and communication systems have been carried out by scientists of Vilnius Gediminas Technical University since 1959.
Romualdas Vadlūga, Romualdas Kliukas
doaj +1 more source
Experimental Study of Confined Low-, Medium- and High-Strength Concrete Subjected to Concentric Compression [PDF]
ITB Journal of Engineering Science, 2012 An experimental study of 23 low-, medium- and high-strength concrete columns is presented in this paper. Square-confined concrete columns without longitudinal reinforcement were designed, and tested under concentric axial compression.
Antonius, Iswandi Imran
doaj +1 more source
Journal and proceedings of the Royal Society of New South Wales, 1901 (Uploaded by Plazi from the Biodiversity Heritage Library) No abstract provided.
openaire +1 more source