Results 301 to 310 of about 269,529 (357)
Programmable automated low-cost IoT water sampler. [PDF]
HardwareXDeleon E +4 more
europepmc +1 more source
The impact of a bundle for the prevention of central venous catheter-associated bloodstream infections in an pediatric surgery intensive care unit. [PDF]
GMS Hyg Infect ControlDevrim İ +12 more
europepmc +1 more source
PAN-00181699 - seal with connecting strip without pin
the able Antiquities of the Netherlands
openalex +1 more source
Corrigendum to "Stress Distribution in 5-Unit Fixed Partial Dentures With a Pier Abutment and Rigid and Nonrigid Connectors With Two Different Occlusal Schemes: A Three-Dimensional Finite Element Analysis". [PDF]
Int J Denteuropepmc +1 more source
SciTextures: Collecting and Connecting Visual Patterns, Models, and Code Across Science and Art [PDF]
Eppel, Sagi, Strugatski, Alona
openalex
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Tenth International Workshop on Software Specification and Design. IWSSD-10 2000, 2002
The ability to construct architectural connectors in a sys tematic and controlled way has been argued to promote reuse and incremental development, e.g., as a way of super posing, a la carte, services like security over a given com munication protocol.
Wermelinger, Michel +2 more
openaire +3 more sources
The ability to construct architectural connectors in a sys tematic and controlled way has been argued to promote reuse and incremental development, e.g., as a way of super posing, a la carte, services like security over a given com munication protocol.
Wermelinger, Michel +2 more
openaire +3 more sources
Transfusion, 1976
Fabrication of a sterile connector for joining a supply source to an independent delivery location through a contaminated environment requires four design steps: 1) alignment of connector housings; 2) exclusion of the contaminated environment; 3) sterilization of the excluded region; and 4) penetration within the sterilized area followed by coupling of
openaire +2 more sources
Fabrication of a sterile connector for joining a supply source to an independent delivery location through a contaminated environment requires four design steps: 1) alignment of connector housings; 2) exclusion of the contaminated environment; 3) sterilization of the excluded region; and 4) penetration within the sterilized area followed by coupling of
openaire +2 more sources