Results 91 to 100 of about 16,330 (207)
As demand for Li‐ion batteries grows, Mn‐rich disordered rocksalt (DRX) oxides offer a sustainable, low‐cost alternative to scarce Ni and Co. During cycling, Mn‐rich DRX materials transform into a partial spinel‐like phase (𝛿) that improves rate capability and capacity.
Han‐Ming Hau +12 more
wiley +1 more source
Abstract Mixed‐conducting ceramic hollow fiber membranes are a versatile platform for oxygen separation, value‐added chemical production, and oxy‐combustion. Because oxygen permeation is thermally activated, these systems typically rely on bulky, energy‐intensive furnaces that suffer from low efficiency and large thermal inertia.
Gang Wang +2 more
wiley +1 more source
Abstract Firefighters face an array of stressors due to the demands of their occupation, leading to a high prevalence of mental health challenges. Social prescribing represents a novel approach to healthcare that emphasizes a holistic view of health and wellbeing.
Janice Ikeda +2 more
wiley +1 more source
A research on the evaluation of grindability of fine-ceramics by constant pressure grinding
Sawa, Takekazu +3 more
openaire +1 more source
Formation mechanism of grinding wheel oxide layer in the ultrasonic-assisted ELID grinding of silicon carbide ceramics. [PDF]
Jia X +6 more
europepmc +1 more source
Enhanced Explosion Characteristics of Methane/Air Induced by Barium Nitrate under a Large Horizontal Pipeline. [PDF]
Sun W, Chen Y, Li D.
europepmc +1 more source
A perfluorinated Zn(II) coordination sheet operates as an interlayer adaptive crystal (LAC), where a small ultramicropore acts as an electrostatic trigger. Guest‐induced breathing driven by fluorinated π‐hole surfaces enables highly selective inclusion of CO2 over N2 and CH4, and benzene over other six‐membered hydrocarbons, beyond the intrinsic ...
Masahiro Abe +5 more
wiley +1 more source
Study on the evaluation of the grindability of the fine ceramics by constant pressure grinding
Sawa, Takekazu +3 more
openaire +1 more source
Research on precise modeling and grinding methods for full tooth surfaces of nonorthogonal face gears. [PDF]
Zhengyang H +5 more
europepmc +1 more source
Multi-Objective Optimization of Material Removal Characteristics for Robot Polishing of Ti-6Al-4V. [PDF]
Chen F, Bao R, Du M, Cheng M, Peng J.
europepmc +1 more source

