Results 171 to 180 of about 17,454 (256)

In‐House Manufacturing of 3D ECM Culture Chips via Vacuum Thermoforming for Enhanced Imaging Applications

open access: yesAdvanced Materials Technologies, EarlyView.
Desktop vacuum thermoforming enables rapid, low‐cost fabrication of 96‐channel polystyrene culture chips with very thin imaging interfaces. The resulting platform supports cell lines, primary cells, and patient‐derived organoids, and enables high‐resolution confocal microscopy and single‐cell visualization, providing an accessible approach for advanced
Aleksandra Fomina   +5 more
wiley   +1 more source

Liquid Crystal Elastomer Actuator Matrix for Large Area Applications

open access: yesAdvanced Materials Technologies, EarlyView.
A scalable approach is used to manufacture a digitally‐controllable, 2D 5 × 5 actuator matrix. The elements of the matrix are produced by direct ink writing of a liquid crystal elastomer ‘artificial muscle’ on large‐area flexible thin‐film heaters. In optimizing the low‐power actuators, multiple heater designs and substrate materials are investigated ...
Giulia Spallanzani   +5 more
wiley   +1 more source

Recent Advances in Transparent Microelectrode Device Architecture and Fabrication Strategies for Biomedical Applications

open access: yesAdvanced Materials Technologies, EarlyView.
Transparent microelectrode arrays enable simultaneous optical and electrical electrophysiology with high spatiotemporal resolution, allowing multimodal observations of dynamic biological systems. Advances in materials and device architectures improve device performance by addressing key trade‐offs between optical transparency, impedance, and ...
Michael Abraham Listyawan   +6 more
wiley   +1 more source

Hierarchically Wrinkled Silver Ink as a Platform for Fully Integrated Stretchable Electronic Systems

open access: yesAdvanced Materials Technologies, EarlyView.
Silver Hierarchical Responsive ink (SHRink), a universal approach for the fabrication of highly stretchable interconnects, wirings, and skin‐interfaced electrodes, is realized through low‐cost, scalable spray‐printing and transfer‐printing. The SHRink demonstrates high electrical conductivity (1.2E04 S cm−1) and large stretchability (235% max fracture ...
Junye Li   +11 more
wiley   +1 more source

Programming Actuation in 3D‐Printed Micro‐Architectures via Interfacial Adhesion Control

open access: yesAdvanced Materials Technologies, EarlyView.
A two‐phase meniscus‐guided 3D printing method directly fabricates microscale poly(3,4‐ethylenedioxythiophene) polystyrene sulfonate (PEDOT:PSS) and poly(vinyl alcohol) (PVA) bilayers with in situ programmable interfaces. Modulating the meniscus stretching speed switches the interface between separated and bonded states, which controls the mechanical ...
Xiao Huan   +13 more
wiley   +1 more source

Home - About - Disclaimer - Privacy