Results 231 to 240 of about 1,845,449 (292)

RF Magnetron Sputtered Tungsten Disulfide Films: Influence of Target Preparation, Deposition Parameters, and Storage Conditions on Thin Film Stoichiometry

open access: yesAdvanced Materials Interfaces, EarlyView.
Sputtered WS2 films were investigated in terms of their S‐ and O‐concentration depending on deposition power and pre‐sputter time. Chemical and structural investigations were done using EDS, TEM, SEM, AFM, XRD. In general, 20 W films exhibit a wide variation in stoichiometry and structure whereas 80 W films demonstrate a higher S/W ratio than 20 W ...
Theresa Scheler   +4 more
wiley   +1 more source

Passive Shape‐Adaptive Fluidic Interface for Enhanced Skin‐Sensor Coupling in Wearable Devices

open access: yesAdvanced Materials Technologies, EarlyView.
This study presents a passive fluidic interface for wearable biosensors that adapts to static and dynamic body shape changes to maintain consistent skin contact. Flexible, fluid‐filled pouches redistribute pressure from high‐load areas to regions requiring improved contact, enhancing signal quality and comfort in a compact, low‐energy design for ...
Natalia Sanchez‐Tamayo   +6 more
wiley   +1 more source

Fabric‐Based Wearable Robotic Exoskeleton Gloves: Advancements and Challenges

open access: yesAdvanced Materials Technologies, EarlyView.
This review highlights interdisciplinary technological advances in fabric‐based robotic gloves, focusing on progress in design, fabrication, actuation, sensing, control, and power and energy requirements. It also addresses performance testing and validation, including biomechanical, strength, functional, user experience, and durability assessments, to ...
Ayse Feyza Yilmaz   +2 more
wiley   +1 more source

Factors associated with satisfaction with teledentistry care among patients from a rural and an urban population in Peru during the COVID-19 pandemic: a cross-sectional survey. [PDF]

open access: yesBMC Public Health
Briceño-Vergel G   +7 more
europepmc   +1 more source

Analysis of consultation responses for Ofqual [PDF]

open access: yes, 2011
Ellison, Gavin   +2 more
core  

Printed Organic Thermoelectric Generators: Progress and Challenges Towards Efficient Energy Harvesting

open access: yesAdvanced Materials Technologies, EarlyView.
Printed organic thermoelectric generators (OTEGs) enable flexible and sustainable energy harvesting from low‐grade heat. This Perspective critically assesses recent advances in printable thermoelectric materials, 2D and 3D device architectures, and current performance limits of printed OTEGs.
Vijitha Ignatious   +5 more
wiley   +1 more source

Home - About - Disclaimer - Privacy