Results 91 to 100 of about 153,980 (264)

Robust Electrocaloric Performance Enabled by Highly‐Polar Frustrated Nanodomains in NaNbO3‐Based Ferrodistortive Relaxor

open access: yesAdvanced Functional Materials, EarlyView.
P4bm framework in NaNbO3‐Ba(Ti, Hf)O3 ferrodistortive relaxor entails short‐range and highly‐polar ferrodistortive orders. The abundant highly‐polar orders facilitate to increase entropy change, and robust octahedral oxygen tilt enables to impede thermal perturbations.
Feng Li   +11 more
wiley   +1 more source

Self‐Sintering Ionogel Binder for Flexible, Recyclable, and Healable Printed Giant Magnetoresistive Sensors

open access: yesAdvanced Functional Materials, EarlyView.
ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo   +10 more
wiley   +1 more source

Research on the Method of Prestressing Tendon Layout for Large-Span Prestressed Components Continuous Rigid Frame Bridge Based on “Zero Bending Moment Dead Load Theory”

open access: yesBuildings
Based on the theory of zero bending moment under constant load, various optimization methods exist for the top beam of large-span continuous rigid frame bridges.
Fanggang Liu   +6 more
doaj   +1 more source

Attosecond metrology in a continuous-beam transmission electron microscope. [PDF]

open access: yesSci Adv, 2020
Ryabov A   +4 more
europepmc   +1 more source

CONTINUOUS BEAMS WITH NON-UNIFORM STIFFNESS

open access: yesActa Physica Sinica, 1953
In this paper, the method of continued fraction is used for the determination of the bending moments of a continuous beam with non-uniform stiffness.
openaire   +2 more sources

Spin Injection Of Exciton–Polaritons With Halide Perovskites At Room Temperature

open access: yesAdvanced Functional Materials, EarlyView.
A monolithic Tamm‐plasmon microcavity embedding a two‐dimensional halide perovskite enables room‐temperature spin injection of exciton‐polaritons under quasi‐resonant optical excitation. Polarization‐resolved spectroscopy reveals partial preservation of the injected spin in the lower polariton branch, while bare excitons remain fully depolarized.
Elena Sendarrubias Arias‐Camisón   +8 more
wiley   +1 more source

Irradiation‐Induced Spin Bath Evolution and as‐Grown Hydrogen Defects in CVD Diamond Revealed by NV‐Based DEER Spectroscopy

open access: yesAdvanced Functional Materials, EarlyView.
Here, we provide the reader with the current state of the art in the fabrication of high‐T2‐coherence diamond, optimized through the use of double electron–electron resonance (DEER) spectroscopy. We reveal the main as well as yet unidentified spin defects, the reduction of which is essential for reducing the spin bath and fabricating materials for ...
Olga Rubinas   +6 more
wiley   +1 more source

Continuous Beam Alignment for Mobile MIMO

open access: yesIEEE Transactions on Wireless Communications
Millimeter-wave transceivers use large antenna arrays to form narrow high-directional beams and overcome severe attenuation. Narrow beams require large signaling overhead to be aligned if no prior information about beam directions is available. Moreover, beams drift with time due to user mobility and may need to be realigned.
Mohamed Naguib   +2 more
openaire   +2 more sources

Spatially Modulated Morphotropic Phase Boundaries in a Compressively Strained Multiferroic Thin Film

open access: yesAdvanced Functional Materials, EarlyView.
ABSTRACT The coexisting rhombohedral‐like (R′, MA) and tetragonal‐like (T′, MC) monoclinic phases in compressively strained bismuth ferrite thin films exhibit exceptional piezoelectric and magnetic properties. While previous studies have largely focused on probing the morphotropic phase boundaries (MPBs) comprising ordered R′/T′ twins, their self ...
Ting‐Ran Liu   +7 more
wiley   +1 more source

Evolution of bonding mechanism and fracture mechanism of Ti alloy-steel joint by dual-beam laser welding using Mg-RE (RE=Gd, Y) filler

open access: yesJournal of Materials Research and Technology
In this paper, a novel coaxial continuous-pulsed dual-beam laser was proposed to join TC4 titanium alloy with QP980 high-strength steel, and magnesium alloy containing rare-earth elements (Mg-RE) was creatively as filler.
Nan li   +6 more
doaj   +1 more source

Home - About - Disclaimer - Privacy