Results 161 to 170 of about 4,881,750 (341)
This work presents a continuous linear gradient catalyst layer design, a general strategy for improving membrane electrode assemblies across electrochemical devices. Fabricated via a dual‐nozzle spray coating method, the architecture controls the Pt/carbon ratio, ionomer content and ionomer type across the catalyst layer, enhancing proton conduction ...
Shangwei Zhou +15 more
wiley +1 more source
Flexural behaviour of hollow reinforced concrete continuous beams reinforced with GFRP bars
Hollow sections have been widely used in structures for passing both the electrical and mechanical utilities, they also allow beams to simply cross one another.
Bassam Qasim Abdulrahman
doaj +1 more source
An All‐Optical Driven Bio‐Photovoltaic Interface for Active Control of Live Cells
Bio‐photovoltaic Interface (BIO‐PV‐I) for live cell manipulation is presented. BIO‐PV‐I can be activated non‐invasively and remotely to control the spatial motility, adhesion, and morphology of cells adhering to it. BIO‐PV‐I uses a patterned light‐induced electric potential in iron‐doped lithium niobate crystals whose light‐driven and reversible nature,
Lisa Miccio +8 more
wiley +1 more source
Three‐dimensional Antimony Sulfide Based Flat Optics
This work presents the development of a grayscale electron beam lithography (g‐EBL) method for fabricating antimony trisulfide (Sb2S3) nanostructures with customizable 3D profiles. The refractive index of g‐EBL patterned Sb2S3 is determined based on the synergy of genetic algorithm and transfer matrix method.
Wei Wang +18 more
wiley +1 more source
A roll‐to‐roll exfoliation method is demonstrated that preserves the crystallographic alignment of anisotropic 2D materials over large areas, enabling scalable fabrication of directional electronic and optoelectronic devices. Abstract Anisotropic 2D materials such as black phosphorus (BP), GeS or CrSBr, exhibit direction‐dependent optical and ...
Esteban Zamora‐Amo +14 more
wiley +1 more source
Shear capacity of miniature beams with continuous staggered spiral stirrups
Scaled-down-reinforced concrete beams with rectangular staggered continuous spiral stirrups are experimentally investigated. Scale-down RC beams were considered in the current research due to ease of construction and economic feasibility.
Ahmed Youssef +2 more
doaj +1 more source
A FeN4─O/Clu@NC‐0.1Ac catalyst containing atomically‐dispersed FeN4─O sites (medium‐spin Fe2+) and Fe clusters delivered a half‐wave potential of 0.89 V for ORR and an overpotential of 330 mV at 10 mA cm−2 for OER in 0.1 m KOH. When the catalyst was used in a rechargeable Zn–air battery, a power density of 284.5 mW cm−2 was achieved with excellent ...
Yongfang Zhou +8 more
wiley +1 more source
This paper is based on the six treatises by the same author which are listed in the introduction. Beams having a horizontal projection in the shape of a broken line, will be referred to in this paper, as broken line beams.
W. Wierzbicki
doaj
Spectrally Tunable 2D Material‐Based Infrared Photodetectors for Intelligent Optoelectronics
Intelligent optoelectronics through spectral engineering of 2D material‐based infrared photodetectors. Abstract The evolution of intelligent optoelectronic systems is driven by artificial intelligence (AI). However, their practical realization hinges on the ability to dynamically capture and process optical signals across a broad infrared (IR) spectrum.
Junheon Ha +18 more
wiley +1 more source
Viscoelasticity‐driven instabilities are harnessed to create tunable, periodic textures in 3D‐printed liquid crystalline polymers. This study illustrates how processing parameters control these spontaneous meso‐scale patterns. These unique structural architectures unlock new possibilities for functional devices, ranging from photonic components to ...
Miaomiao Zou +17 more
wiley +1 more source

