Results 11 to 20 of about 35,894 (264)
Metals, 2021 Based on low-temperature high-permeability grain-oriented silicon steel designed with an initial nitrogen content of 0.0055% and produced by the thin slab casting and rolling process, the effect of total nitrogen content and nitriding temperature on ...
Bing Fu +5 more
doaj +1 more source
Metals, 2021 Optimum grain size and effects of crystallographic textures on magnetic properties of Fe-0.65%Si non-oriented electrical steel produced by compact strip production (CSP) process were investigated by optical microscope, electron backscatter diffraction ...
Junqiang Cong +4 more
doaj +1 more source
Microstructure and texture of Hi-B steel produced by TSCR process
工程科学学报, 2016 The microstructure and texture evolution of Hi-B steel produced by thin slab casting and rolling (TSCR) process in the laboratory was studied by metalloscopy and scanning electron microscopy.
XIAO Li-jun +4 more
doaj +1 more source
Control of the Non-Metallic Inclusions near Solidification Front by Pulsed Magnetic Field
Metals, 2022 Aiming to investigate the behavior of non-metallic inclusions near an advancing solid-liquid interface and the effect of a pulsed magnetic field on the distribution of inclusions, motions of inclusions without and within a pulsed magnetic field were ...
Zhimin Cui +5 more
doaj +1 more source
Metals, 2023 In this study, the two-phase flow coordination characteristics between α and β phases of H62 brass made by up-drawing continuous casting are investigated based on the upsetting process. An in situ and new research method for two-phase flow is put forward,
Bing Li +7 more
doaj +1 more source
Mass-Transfer Model for Steel, Slag, and Inclusions during Ladle-Furnace Refining
High Temperature Materials and Processes, 2018 Precise control of inclusion and molten steel compositions during ladle-furnace refining is important to obtain high-quality steel. Mass-transfer behavior affects these compositions.
Zhu Liguang +5 more
doaj +1 more source
Simulation experiments and mechanism of medium plate edge folding
工程科学学报, 2015 The formation mechanism and influencing factors of fold defects at the medium plate edge were studied by detecting and analyzing edge folding samples. It is found that the plate edge folding phenomenon results from the transformation of slab lateral side
MA Zhong-wei +4 more
doaj +1 more source
Study on steel deoxidation with Al-Ca compound alloy
工程科学学报, 2017 The thermodynamic diagram of calcium-aluminum-oxygen ternary system was determined through thermodynamic equilibrium calculation of liquid steel deoxidation.
WANG Xiao-ying +3 more
doaj +1 more source
Metals, 2023 The technology of submerged carbon powder injection with CO2 and O2 mixed gas (SCPI-COMG) is a new type of powder injection technology. It can increase the molten bath carbon content and improve the molten steel quality by injecting carbon powder ...
Jianjun Li, Guangsheng Wei, Chengjin Han
doaj +1 more source
Metals, 2018 The effect of Mg treatment on the microstructure and toughness of the heat-affected zone (HAZ) of shipbuilding steel after high-heat-input welding was investigated via laboratory and industrial testing.
Yan Wang +4 more
doaj +1 more source