Results 21 to 30 of about 17,761,311 (335)
Cost-Effective and High-Efficiency Variable-Speed Switched Reluctance Drives With Ring-Connected Winding Configuration [PDF]
This paper presents a novel converter topology for six-phase switched reluctance motor (SRM) drives, which reduces the number of switches and diodes by half, compared with the conventional asymmetric half-bridge converter, but needs no additional energy ...
Deng, Xu +4 more
core +2 more sources
Research on Control Strategy of Voltage Source Full Power Wind Power Converter
In the operating environment of power system with weak grid characteristics, the traditional current source converter control mode is prone to vibration, which increases the crossing difficulty and off-grid probability of wind turbines.
ZHOU Wang +5 more
doaj +3 more sources
Design and implementation of 30kW 200/900V LCL modular multilevel based DC/DC converter for high power applications [PDF]
This paper presents the design, development and testing of a 30kW, 200V/900V modular multilevel converter (MMC) based DC/DC converter prototype. An internal LCL circuit is used to provide voltage stepping and fault tolerance property.
Aboushady, A. +3 more
core +2 more sources
Validation Aspects for Grid-Forming Converters Based on System Characteristics and Inertia Impact
Grid-forming converters are considered a key technology for electrical grids with a high share of renewable energy. However, there is a lack of a general, robust and verifiable definition of what constitutes this behaviour. Therefore, this paper presents
Julian Struwe +2 more
doaj +1 more source
Evaluation of a dual-T-type converter supplying an open-end winding induction machine [PDF]
The multilevel inverter is a promising technology compared to two-level inverters in the applications of ac-drives and smart-grid applications. In this paper, a dual-T-type three-level inverters is used to drive an open-end winding induction machine. The
Darba, Araz +5 more
core +1 more source
An accurate calculation of short-circuit current (SCC) is very important for relay protection setting and optimization design of electrical equipment. The short-circuit current for a doubly-fed induction generator wind turbine (DFIG-WT) under excitation ...
Jing Li, Tao Zheng, Zengping Wang
doaj +1 more source
One of the major failure causes in the power modules comes from the severe thermal stress in power semiconductor devices. Recently, some local control level methods have been developed to balance the power loss, dealing with the harsh mission profile, in
Luocheng Wang, Tiefu Zhao, Jiangbiao He
doaj +1 more source
Advanced classification of converter control concepts for integration in electrical power systems
As decarbonized power systems are mainly based on power electronic converters, the operational behavior of electrical power systems will be more and more determined by the control concepts of these converters.
Stefan Henninger, J. Jaeger
semanticscholar +1 more source
High Frequency Pulse Width Modulation Converters [PDF]
The delta modulation technique permits an accurate of an arbitrary reference. Spectrum of the current going through an inductive load shows a very low THD.
Ahmed Hassan Mohammed
doaj +1 more source
Electric vehicles are receiving widespread attention around the world due to their improved performance and zero carbon emissions. The effectiveness of electric vehicles depends on proper interfacing between energy storage systems and power electronics ...
M. S. Lipu +8 more
semanticscholar +1 more source

