Results 91 to 100 of about 121,796 (309)
EnergiesWith the increasing global demand for sustainable energy, the importance of advanced nuclear technologies, such as fourth-generation reactors, has become increasingly prominent.
Mian Xing +6 more
doaj +1 more source
Jet pump-drive system for heat removal [PDF]
A jet pump, in combination with a TEMP, is employed to assure safe cooling of a nuclear reactor after shutdown. A TEMP, responsive to the heat from the coolant in the secondary flow path, automatically pumps the withdrawn coolant to a higher pressure and
French, J. R.
core +1 more source
Optimal microscale water cooled heat sinks for targeted alleviation of hotspot in microprocessors [PDF]
, 2014 This paper was presented at the 4th Micro and Nano Flows Conference (MNF2014), which was held at University College, London, UK. The conference was organised by Brunel University and supported by the Italian Union of Thermofluiddynamics, IPEM, the ...
4th Micro and Nano Flows Conference (MNF2014) +3 more
core
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Development of Tool Edge Temperature Measurement Method in Wet Cutting
Journal of Advanced Mechanical Design, Systems, and Manufacturing, 2012 In this paper, the measurement method of tool edge temperature using a two-color pyrometer with an optical fiber in wet cutting is proposed. Using the proposed method, the high pressure air supplied from the small hole where an optical fiber is inserted ...
Hideto NISHIMOTO +4 more
doaj +1 more source
Aerodynamic effect of a honeycomb rotor tip shroud on a 50.8-centimeter-tip-diameter core turbine [PDF]
A 50.8-cm-tip-diameter turbine equipped with a rotor tip shroud of hexagonal cell (or honeycomb) cross section has been tested in warm air (416 K) for a range of shroud coolant to primary flow rates.
Moffitt, T. P., Whitney, W. J.
core +1 more source
The performance of components in the Skylab refrigeration system [PDF]
, 1975 The on-orbit performance of the Skylab refrigeration system components is presented. Flight anomalies are analyzed and performance of the newly developed components is described.
Daniher, C. E., Jr.
core +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Analysis for predicting adiabatic wall temperatures with single hole coolant injection into a low speed crossflow [PDF]
Assuming the local adiabatic wall temperature equals the local total temperature in a low speed coolant mixing layer, integral conservation equations with and without the boundary layer effects are formulated for the mixing layer downstream of a single ...
Graham, R. W. +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source