Results 211 to 220 of about 4,047,721 (330)
Research on vehicle trajectory planning algorithm integrating spatiotemporal constraints and adaptive curvature. [PDF]
Zhao Y, Wang J, Li P, Wang H.
europepmc +1 more source
Sol–Gel Derived Polymer Precursors for Stereolithography of ZrC
ZrC is a critical material target for extreme temperature conditions. This report describes a protocol for preparing ZrC ceramics via stereolithography and examines the impact of the polymer matrix on carbothermal reduction and mechanical stability of 3D printed ZrC.
Charles J. Rafalko +2 more
wiley +1 more source
Vision-Based Vehicle State and Behavior Analysis for Aircraft Stand Safety. [PDF]
Tang K +5 more
europepmc +1 more source
Micro‐Raman spectroscopy is applied to characterize corrosion products in a recycled‐based MgO–316L steel composite anode after molten salt electrolysis. A depth‐dependent Fe–O/Fe–Al–O layer sequence of magnetite, hercynite, and an Al‐doped magnetite transition zone is identified.
Felix Drechsler +9 more
wiley +1 more source
Analysis and Simulation Verification of the Verticality Measurement Model for Single Offshore Pile Based on Binocular Vision. [PDF]
Li S, Zhu Y, Cao Y, Li X, Zhou Z.
europepmc +1 more source
Towards Defect Phase Diagrams: From Research Data Management to Automated Workflows
A research data management infrastructure is presented for the systematic integration of heterogeneous experimental and simulation data required for defect phase diagrams. The approach combines openBIS with a companion application for large‐object storage, automated metadata extraction, provenance tracking and federated data access, thereby supporting ...
Khalil Rejiba +5 more
wiley +1 more source
A Sensorless Rotor Position Detection Method for Permanent Synchronous Motors Based on High-Frequency Square Wave Voltage Signal Injection. [PDF]
Song A, Feng Z, Huang B, Ning B.
europepmc +1 more source
This study develops sustainable MgO–C refractories using recycled materials and eco‐friendly fructose–tannin binders. The enhanced performance of citric acid as a cross‐linker and functional additives on mechanical and thermomechanical properties was examined. Characterization included strength tests, immersion trials, and microstructural and inclusion
Dinesh K. Gunasekar +7 more
wiley +1 more source
A Scheme for System Error Calibration and Compensation of the Initial State of MEMS Inertial Navigation. [PDF]
Ding X, Chen Z, Wu Z, Wang X.
europepmc +1 more source

