Results 51 to 60 of about 881,336 (175)
, 2021 International audienceThe present study investigates the mechanical behavior of severely plastic-deformed Cu-Al composite wires with different diameters and heat-treatments. Each composite holds 61 restacked copper-clad aluminum wires.
Hug, E. +19 more
core +1 more source
American Journal of Human Biology, Volume 38, Issue 10, October 2026.ABSTRACT Introduction Increasing salinity of groundwater is a global environmental health threat that has been overlooked in human biology and may increase the risk of water insecurity, dehydration, chronic kidney disease (CKD), and hypertension in humans. However, no health standards exist for salinity levels in drinking water.
Alfredo J. Rojas Jr. +11 more
wiley +1 more source
The Anatomical Record, Volume 309, Issue 10, Page 2725-2738, October 2026.Abstract In birds, the neural canal houses a variety of anatomical structures including the spinal cord, meninges, spinal vasculature, and respiratory diverticula. Among these, paramedullary diverticula and the extradural dorsal spinal vein may leave behind osteological correlates in the form of pneumatic foramina and fossae, and a bilobed geometry of ...
Jessie Atterholt +5 more
wiley +1 more source
EcoEnergy, Volume 4, Issue 5, October 2026.This review highlights emerging integrated energy systems based on perovskite photovoltaics, including PSC–thermoelectric, photovoltaic–electrochemical, self‐charging, and building‐integrated architectures. By coupling multiple energy conversion and storage pathways, these multifunctional platforms enable enhanced solar utilization, improved stability,
Yihuai Huang +10 more
wiley +1 more source
Strength and HRTEM microstructure at bond interface of aluminum/copper clad materials [PDF]
It is known that it is difficult to bond dissimilar metals such as aluminum and copper or aluminum and iron using diffusion bonding, because an intermetallic compound is easily produced at the bond interface and bonding strength becomes low.
山口, 富子 +19 more
core
Global Challenges, Volume 10, Issue 10, October 2026.All‐cellulose composites produced from cotton textiles were evaluated for sustainability and mechanical performance. Adding dimethyl sulfoxide (DMSO) to the ionic liquid 1‐ethyl‐3‐methylimidazolium acetate (EMIM OAc) reduced environmental burdens while preserving high stiffness.
Guanyi Chen +4 more
wiley +1 more source
Experimental Measurements Of Air Forced Convection Through Copper Foams [PDF]
, 2012 This paper aims at investigating the air heat transfer and fluid flow through open-cells copper foam samples with different number of pores per unit of length (PPI) with constant porosity (ε=0.93) and foam core height of 40 mm.
Mancin, Simone +3 more
core
Cu–Al interfacial compounds and formation mechanism of copper cladding aluminum composites
Transactions of Nonferrous Metals Society of China, 2017 Abstract Copper cladding aluminum (CCA) rods with the section dimensions of 12 mm in diameter and 2 mm in sheath thickness were fabricated by vertical core-filling continuous casting (VCFC) technology. The kinds and morphology of interfacial intermetallic compounds (IMCs) were investigated by SEM, XRD and TEM.
Di CHU +4 more
openaire +1 more source
Fabrication and evaluation of brazed titanium-clad Borsic/aluminum compression panels [PDF]
, 1980 Processes for brazing Borsic/aluminum composite materials that eliminate diffusion of braze alloy constituents into the aluminum matrix developed. One brazing study led to the development of a hybrid composite which combines high strength Borsic/aluminum
Royster, D. M. +2 more
core
Metallurgical and Mechanical Properties of Wire-Mesh Reinforced Dissimilar Explosive Cladding
, 2018 Explosive cladding employs a controlled chemical explosive detonation to craft a metallurgical bond between similar and dissimilar metals. Aluminum 5052-copper and aluminum 5052-aluminum 1100 plates are explosively cladded with a stainless steel wire ...
Somasundaram Saravanan +1 more
core +1 more source