Results 121 to 130 of about 148,672 (304)
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
Advanced Engineering Materials, EarlyView.This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source
Multiscale analysis of crystalline defect formation in rapid solidification of pure aluminium and aluminium-copper alloys. [PDF]
Philos Trans A Math Phys Eng Sci, 2022 Pinomaa T +8 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Brazilian Dental Journal, 2003 Copper/aluminum alloys are largely utilized in odontological restorations because they are less expensive than gold or platinum. However, tarnishing and important corrosion in intrabuccal prostheses made with copper/aluminum alloys after 28 days of use ...
Rodrigues Luiz Erlon A. +4 more
doaj
New Copper Alloys Used to Make Products Intended for Contact with Drinking Water. [PDF]
Materials (Basel), 2021 Chruściński M +4 more
europepmc +1 more source
Friction and wear of titanium alloys and copper alloys sliding against titanium 6-percent-aluminum - 4-percent-vanadium alloy in air at 430 C [PDF]
Experiments were conducted to determine the friction and wear characteristics of aluminum bronzes and copper-tin, titanium-tin, and copper-silver alloys sliding against a titanium-6% aluminum-4% vanadium alloy (Ti-6Al-4V).
Wisander, D. W.
core +1 more source
Wet and dry accelerated aging tests in a spray chamber to understand the effects of acid rain frequencies on bronze corrosion [PDF]
, 2013 We have conducted controlled laboratory experiments using a series of bronze alloys exposed to frequent, repeated wet and dry cycles, to simulate frequent acid rain exposure and study the resultant corrosion processes in bronze artifacts exposed to an ...
Adriaens, Mieke +3 more
core
Advanced Engineering Materials, EarlyView.Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin +5 more
wiley +1 more source
Reduction of Magnetic Noise in Atom Chips by Material Optimization
, 2005 We discuss the contribution of the material type in metal wires to the electromagnetic fluctuations in magnetic microtraps close to the surface of an atom chip.
Bass +28 more
core +1 more source
Advanced Engineering Materials, EarlyView.EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source