Results 11 to 20 of about 137,375 (214)
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Method of producing porous tungsten ionizers for ion rocket engines Patent [PDF]
Method for producing porous tungsten plates for ionizing cesium compounds for propulsion of ion ...
Saunders, N. T.
core +1 more source
A Compact Spin‐Coated Graphene UWB Antenna for Breast Tumor Detection
A compact, spin‐coated graphene ultra‐wideband patch antenna designed for breast tumor detection, capable of distinguishing between malignant and benign tumors. This innovative antenna can serve as an effective initial screening tool, particularly in resource‐limited settings such as rural areas, where access to advanced medical equipment like MRI and ...
Raja Rashidul Hasan +9 more
wiley +1 more source
Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies
Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo +3 more
wiley +1 more source
Evacuation of coal from hoppers/silos with low pressure pneumatic blasting systems [PDF]
The need for an efficient, economical, effective and quiet device for moving coal and other difficult bulk solids was recognized. Thus came the advent of the low pressure pneumatic blasting system - a very efficient means of using a small amount of plant
Fischer, J. S.
core +1 more source
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
A Resonant soft x-ray powder diffraction study to determine the orbital ordering in A-site ordered SmBaMn2O6 [PDF]
Soft X-ray resonant powder diffraction has been performed at the Mn L2,3 edges of A-site ordered SmBaMn2O6. The energy and polarization dependence of the (1/2 1/2 0) reflection provide direct evidence for a (x2-z2)/(y2-z2) type orbital ordering in ...
Bodenthin, Y. +8 more
core +1 more source
Creep experiments at 900°C on coarse‐grained steel‐ceramic composites containing recycled magnesia reveal that higher ceramic volume fractions significantly enhance the creep resistance. Detailed EBSD investigations identify subgrain formation in the steel matrix as the dominant deformation mechanism.
Moritz Müller +6 more
wiley +1 more source
Handbook of Establishing and Maintaining Oxygen‐Free Atmospheres
This study presents a practical framework for creating oxygen‐free atmospheres at ambient pressure using silane‐doped inert gases. The results show that ultra‐low oxygen levels and strongly reduced water content can be achieved through controlled silane dosing, drying systems, and sensor monitoring.
Sascha Jan Zimmermann +3 more
wiley +1 more source
Self-Heating Ability of Geopolymers Enhanced by Carbon Black Admixtures at Different Voltage Loads [PDF]
Sustainable development in the construction industry can be achieved by the design of multifunctional materials with good mechanical properties, durability, and reasonable environmental impacts.
Fiala L. +4 more
core +1 more source

