Results 221 to 230 of about 332,885 (287)

Preparation and long-term corrosion resistance of epoxy resin coatings modified by Fe-Co-Ni-Cr-Ti high-entropy alloy. [PDF]

RSC Adv
Fan X, Liu Y, Ji G.
europepmc   +1 more source

Inspired Fluorinated BDD Film for Multifunctional Protection of Downhole Sensor Electrodes. [PDF]

Nanomaterials (Basel)
Liu J, Zhao S, Wang J, Liu J, Yu X, Zhang J.   +5 more
europepmc   +1 more source

The effectiveness of Ni@SiTiCNO nanocomposite coating for protecting steel used in agricultural machinery dealing with animal waste. [PDF]

Sci Rep
Nasr GEM, Refai MA, Elaziz AGA, Gomaa MH, El-Sheikh SM, Ahmed YMZ, Hamid ZA.   +6 more
europepmc   +1 more source

Robust multi-objective metaheuristic optimization of Cr(III) electrodeposition on 42CrMo4 steel for energy-efficient wear resistance. [PDF]

Sci Rep
Amar T, Selman D, Abdelhamid G.
europepmc   +1 more source

Advances in Materials Joining and Additive Manufacturing. [PDF]

Materials (Basel)
Liu X, Shi L.
europepmc   +1 more source

Review of Failure Mechanisms of Steel Wire Ropes Under Heavy-Load Conditions and the Anti-Friction Effects of Gel-like Grease. [PDF]

Gels
Peng H, Zhang Y, Shangguan L, Zhao M, Li B, Yang L, Liu Y.   +6 more
europepmc   +1 more source

EROSION-CORROSION-WEAR PROGRAM

, 1980
openaire   +1 more source

The Effect of Yttrium on Wear, Corrosion and Corrosive Wear of Mg-Al Alloys [PDF]

, 2017
Magnesium remarkably deserves considerable interest from industry especially transportation sector because of its high strength to weight ratio. However, poor wear resistance and low corrosion resistance of magnesium are barriers to extend use of its alloys.
Nouri, Meisam
openaire   +2 more sources

Some of the next articles are maybe not open access.

Related searches:

Wear and Corrosion

2013
Wear can be defined as the loss of material that occurs when two surfaces rub against each other. Two common forms of wear are:
Nikhilesh Chawla, Krishan K. Chawla
openaire   +1 more source

Corrosion of amalgams under sliding wear

Dental Materials, 1996
During mastication, dental amalgams are simultaneously subjected to corrosion by the oral environment and to a sliding-wear process by biting forces. In the present study, the effect of sliding wear on the corrosion behavior of two high-copper dental amalgams was investigated.An experimental apparatus was utilized that allows electrochemical testing ...
K, Lian, E I, Meletis
openaire   +2 more sources