Results 31 to 40 of about 3,852 (197)
In this study, two kinds of corrugated louver fin-and-tube heat exchangers – one having one corrugation per row and the other having two corrugations per row – were tested under wet condition, and the results were compared with those of the standard ...
Nae-Hyun KIM
doaj +1 more source
Advances in Magnesium‐Based Thermoelectrics: A Critical Review
Magnesium‐based thermoelectric materials have emerged as promising candidates for low‐to‐mid‐temperature energy conversion due to their abundance, low cost, and competitive performance. This review summarizes recent advances in Mg3X2, MgAgSb, and Mg2X systems, covering transport mechanisms, fabrication strategies, stability challenges, and device ...
Li‐Min Zhang +5 more
wiley +1 more source
The calculus simulation to predict reliably heat transfer coefficient
Strengthening heat transfer for energy conservation challenges current longer times and higher experimental costs on laboratory scale test, pilot scale test, industrialized production.
Kang Dai +6 more
doaj +1 more source
A flexible piezoresistive pressure sensor with gradient toroidal CNT/PDMS microstructures is reported. The hierarchical geometry enables sequential electrode contact, achieving a sensitivity of 256.20 kPa−1 and linear response (R2 = 0.99) over 0–1000 kPa.
Rongmei Wang +8 more
wiley +1 more source
ObjectiveIn daily operation, the outer wall of solar receiver tube is subjected to uneven heat flux between the inner and outer sides at cylindrical receiver, which leads to the uneven distribution of wall temperature and large temperature gradient.
ZENG Xianmin +4 more
doaj +1 more source
Thin-walled galvanized helical corrugated steel tubes (HCSTs) filled with concrete are promising composite members, consisting of concrete, an anti-corrosion shell, and a multifunctional exterior corrugated steel tube.
Haibo Sun +4 more
doaj +1 more source
Advancing Tube Receiver Performance by Using Corrugated Tubes
AbstractDirect introduction of solar energy into a Brayton cycle using Solar Tower systems enables a highly efficient conversion of the solar energy, especially so when combined cycles are used. One key component of such a solar gas turbine system is the receiver.
Uhlig, Ralf +2 more
openaire +1 more source
Advances in Electroactive Liquid Crystal Elastomers for Intelligent Robotics and Electronics
Electroactive liquid crystal elastomers (eLCEs) integrate molecular anisotropy with electrical functionality to enable programmable actuation and reconfigurable electronics. This review classifies eLCEs into robotic actuators and adaptive electronics, summarizes key actuation mechanisms, and highlights fabrication strategies that bridge materials to ...
Kavita Ramesh Rathod +14 more
wiley +1 more source
Computational results of flow structure, pressure loss and heat transfer characteristics in triple-start corrugated tubes are reported. The influences of the depth ratio (DR = 0.02, 0.04, 0.06, 0.08, 0.1, 0.12, 0.14 and 0.16) and pitch ratio (PR = 0.5, 0.
Pitak PROMTHAISONG +2 more
doaj +1 more source
Observation of Excitonic Instability in a Monolayer Ta2NiSe5 With Strain Disorder
Monolayer Ta2${\rm Ta}_2$NiSe5${\rm NiSe}_5$ sustains an excitonic insulating phase up to 190 K, with Raman signatures of gap opening and critical excitonic fluctuations. Thickness‐independent large gap ratios highlight strong exciton‐phonon coupling, while substrate‐induced strain disorder depresses Tc, establishing monolayer Ta2${\rm Ta}_2$NiSe5${\rm
So Young Kim +13 more
wiley +1 more source

